本文選題：鋁基復合材料　切入點：分散性　出處：《熱加工工藝》2016年18期

【摘要】：對碳纖維進行預處理后與鋁粉機械混合,用壓力機制備預制塊,將過熱鋁液與預制塊混合并澆注試樣。結果表明:行星球磨機轉速300 r/min,混制時間20 min的條件下,可獲得分散度較好的預制塊粉末;壓強為20 MPa、保壓為2.5~3 min的工藝條件下,獲得了較好的預制塊,并與860℃的過熱鋁液混合后澆注試樣;經過激光刻蝕、高溫灼蝕、化學鍍銅預處理的短碳纖維比未經過預處理的碳纖維在鋁基體中的分散效果好。
[Abstract]:Carbon fiber was pretreated and mixed with aluminum powder mechanically. Prefabricated blocks were prepared by press, superheated aluminum liquid and prefabricated blocks were mixed and cast samples. The results showed that the speed of planetary ball mill was 300rmin and the mixing time was 20 min. The prefabricated powder with good dispersion can be obtained. Under the conditions of 20 MPA pressure and 2.5 min holding pressure, a better prefabricated block is obtained, which is mixed with superheated aluminum liquid at 860 鈩，

本文編號：1653021