金屬-鑄型界面反應法制備鎂合金合金化表層的熱力學分析及試驗研究
發布時間:2018-03-13 14:47
本文選題:合金化表層 切入點:前驅體 出處:《兵器材料科學與工程》2017年03期 論文類型:期刊論文
【摘要】:提出鎂合金凝固過程中與預置在鑄型表面的合金元素前軀體反應,制備鎂合金合金化表層的新思路。以ZnS為前軀體計算分析其熱力學可行性,并進行相關試驗研究。結果表明:Mg與ZnS反應生成Zn和Mg S,在693~1 000 K具有熱力學可行性;液態Mg在表面預置ZnS的鑄型中凝固后,Mg表面Zn的質量分數為10.0%,Zn的質量分數由表及里逐步降低,表面以下距離超過35μm后,Zn的質量分數近乎為0。
[Abstract]:A new way of preparing magnesium alloy alloying surface was put forward in this paper. The thermodynamics feasibility of magnesium alloy alloying surface was analyzed by using ZnS as precursor calculation. The experimental results show that Zn and MgS are formed by the reaction of ZnS with 1: mg, which is thermodynamically feasible at 693K. After solidification, the mass fraction of Zn on mg surface decreases gradually from outside to inside in the casting mould of ZnS with liquid mg. The mass fraction of Zn on the surface is nearly zero after the distance below the surface is over 35 渭 m.
【作者單位】: 重慶大學材料科學與工程學院;國家鎂合金材料工程技術研究中心;
【基金】:重慶市科技計劃項目應用開發計劃重大項目(cstc2015yykf C50001) 中國國家大學生創新計劃(201610611041)
【分類號】:TG174.445
,
本文編號:1606847
本文鏈接:http://sikaile.net/shekelunwen/minzhuminquanlunwen/1606847.html
最近更新
教材專著