本文選題：光柵 + 光纖布拉格光柵　； 參考：《激光與光電子學進展》2016年11期

【摘要】：利用裸光纖布拉格光柵測量結構物表面應變,基于光纖層-膠結層-基體層的應變傳遞模型,從理論上分析了預張拉對應變傳遞率的影響,并通過實驗進行了驗證。利用預張拉光柵與未預張拉光柵同時測量了等強度梁正反兩面的應變。實驗中為排除黏貼長度及厚度的影響,采用LOCTITE點膠機控制滴膠量,得到應變隨荷載變化的曲線,并與等強度梁理論應變值進行對比,得到應變傳遞率與荷載的關系曲線。結果表明,在測拉應變時,預張拉光柵的應變傳遞率高于未預張拉光柵的應變傳遞率,且兩者都在96%以上;在測壓應變時,預張拉光柵的應變傳遞率低于未預張拉光柵的應變傳遞率,且兩者均在95%以上,與理論分析相符。這說明對測拉應變的實驗,預張拉能提高應變傳遞率;而對測壓應變的實驗,預張拉會降低應變傳遞率。
[Abstract]:Based on the strain transfer model of fiber layer, cemented layer and matrix layer, the effect of pretension on the strain transfer rate is analyzed theoretically and verified by experiments by using bare fiber Bragg grating (FBG) to measure the strain on the surface of the structure. The strain on both sides of equal strength beam is measured simultaneously by using pretension grating and unpretension grating. In order to eliminate the influence of adhesive length and thickness, the strain variation curve with load was obtained by using LOCTITE spotting machine, and compared with the theoretical strain value of equal strength beam, the relation curve between strain transfer rate and load was obtained. The results show that the strain transfer rate of pretension gratings is higher than that of unpretensioned gratings, and both of them are above 96%. The strain transfer rate of pretension gratings is lower than that of unpretensioned gratings, and both of them are above 95%, which is consistent with the theoretical analysis. This shows that pretension can improve the strain transfer rate in the experiment of measuring tensile strain, while in the experiment of measuring compressive strain, pretension can reduce the strain transfer rate.
【作者單位】： 中國人民解放軍理工大學爆炸沖擊防災減災國家重點實驗室;
【基金】：國家973計劃(2013CB036005) 江蘇省基礎研究計劃(SBK2016021801)
【分類號】：TP212

【相似文獻】

相關會議論文 前2條

1 王新民;吳群慧;;聚丙烯高分子土工帶力學特性分析與預張拉技術的研究[A];材料科學與工程技術——中國科協第三屆青年學術年會論文集[C];1998年

2 蔣田勇;方志;;預張拉CFRP筋在RPC中的錨固性能[A];第五屆全國FRP學術交流會論文集[C];2007年

相關碩士學位論文 前2條

1 伯志林;鋼絲繩結構伸長及其預張拉研究[D];武漢理工大學;2003年

2 陳孟杰;預應力空心板梁預張拉性能分析及截面優化設計研究[D];浙江大學;2006年

，

本文編號：2085634