本文選題：氨氣 + 傳感器�。� 參考：《儀表技術與傳感器》2017年11期

【摘要】：為了提高傳感器的靈敏度和使用壽命,利用化學還原法制備了釕催化劑并對其進行了X射線衍射(XRD)表征。在電極制備過程中,釕催化劑與造孔劑硝酸鉀的質量比為2∶1,利用絲網印刷技術制備出多孔電極。將未加造孔劑和加造孔劑的電極分別進行了掃描電鏡(SEM)表征并組裝成傳感器,在同等條件下對氨氣進行檢測,分別通入不同濃度氨氣標準氣體,測得其靈敏度分別為230μA和450μA,響應時間分別為103 s和40 s,恢復時間分別為115 s和60 s。加入造孔劑后,靈敏度提高了49%,響應時間和恢復時間分別縮短了63 s和55 s,顯著提高了氨氣傳感器的性能。
[Abstract]:In order to improve the sensitivity and service life of the sensor, ruthenium catalyst was prepared by chemical reduction method and characterized by X-ray diffraction (XRD). In the process of electrode preparation, the mass ratio of ruthenium catalyst and pore-making agent potassium nitrate was 2: 1. The porous electrode was prepared by screen printing technology. The electrodes without pore-making agent and pore-making agent were characterized by scanning electron microscope (SEM) and assembled into a sensor. Ammonia gas was detected under the same conditions and passed into different concentrations of ammonia gas. The sensitivity is 230 渭 A and 450 渭 A, the response time is 103 s and 40 s, and the recovery time is 115 s and 60 s, respectively. After the addition of pore-forming agent, the sensitivity was increased by 49, the response time and recovery time were shortened by 63 s and 55 s, respectively, and the performance of ammonia gas sensor was improved significantly.
【作者單位】： 吉林省電力科學研究院有限公司;中國科學院長春應用化學研究所;
【分類號】：TP212

【相似文獻】

相關博士學位論文 前1條

1 陳健生;納米氧化物半導體電極材料的制備與電化學生物傳感應用[D];吉林大學;2012年

，

本文編號：1798560