本文關鍵詞： 激光數控加工 逆向工程 風機葉片模塊　出處：《激光雜志》2017年08期 　論文類型：期刊論文

【摘要】：當前風機葉片模塊設計過程復雜,性能低下,為此設計激光數控加工逆向工程風機葉片模塊。通過簡化設計方法對外形設計的基本參數進行確定,獲取風速和相應參數之間的關系,依據風機葉片結構要求,通過葛勞渥方法完成初步的氣動性能分析與調整,實現激光數控加工逆向工程風機葉片模塊外形的設計。確定葉片的初始參數,令風機葉片各截面葉素的輸出功率最大。實驗結果表明,所設計風機葉片模塊壓力分布均勻,升力高,滿足設計要求。
[Abstract]:At present, the design process of fan blade module is complicated and the performance is low. For this reason, laser numerical control machining fan blade module is designed. The basic parameters of shape design are determined by simplified design method. The relationship between the wind speed and the corresponding parameters is obtained. According to the structural requirements of the fan blade, the preliminary aerodynamic performance analysis and adjustment are completed by the Grawwood method. The design of the shape of the blade module of reverse engineering fan is realized by laser NC machining. The initial parameters of the blade are determined, and the output power of the blade element of each section of the fan blade is maximum. The experimental results show that the pressure distribution of the fan blade module is uniform. High lift to meet the design requirements.
【作者單位】： 武昌工學院;
【基金】：湖北省教育廳科學技術研究計劃指導性項目(B2015262)
【分類號】：TG659;TN249

【相似文獻】

相關期刊論文 前1條

1 伍先俊,李志明;風機葉片噪聲機理及降噪[J];風機技術;2001年04期

，

本文編號：1540771