本文選題：光纖通道　切入點：實時性　出處：《電子科技大學》2014年碩士論文

【摘要】：隨著現代綜合電子信息系統的發展,對數據傳輸業務的實時性要求越來越高,傳統的通信網絡已經不能滿足需求,而光纖通道(Fibre Channel,FC)可以支持多種傳輸速率、多種拓?fù)浜投喾N上層協議,成為嵌入式高速通信網絡的一種高帶寬、高實時性、高可靠、高擴展性的解決方案。但是FC核心技術由國外博科等少數廠家壟斷,而國內沒有統一的FC技術標準,特別是在FC網絡實時性保障問題方面更沒有統一的標準解決方案,亟需研制自主可控的FC解決方案。本文針對上述FC網絡實時性技術保障問題,結合技術可行性,選擇光纖通道作為特定網絡環境下的骨干網絡進行研究分析和技術驗證。主要工作有以下幾個方面:1、研究了光纖通道技術相關的標準規范協議和PCI Express總線協議,對光纖通道端口類型、傳輸服務類型、網絡結構、IPFC協議以及PCI Express總線DMA控制技術等進行了重點研究。2、針對FC網絡實時性技術進行研究,從基于優先級的分組調度設計和數據高速收發設計等兩個方面提出FC網絡接口卡實時性設計,從交換結構設計和交換優先級支持等兩個方面提出FC網絡交換實時性設計。3、完成FC網絡接口卡和FC網絡交換機方案設計、原理圖和硬件設計、調試開發,以及完成主要基于FPGA的FC網絡實時性技術實現與仿真驗證。4、搭建FC網絡實時性測試環境,對FC網絡接口卡和FC網絡交換機的實時性功能進行了測試,并對測試結果進行了分析。測試結果表明,本文設計實現的FC網絡接口卡FC端口速率為2.125Gbps,端口數2個,支持PCI-E×4通道,支持FC網絡接入通信能力,支持IP over FC協議映射,滿足實時性要求;FC網絡交換機端口速率為2.125Gbps,端口數12個,交換容量不小于24Gbps,最大交換時延小于30us。FC網絡接口卡和FC網絡交換機能滿足特定FC網絡數據傳輸功能和性能上的要求,為實現多網融合和信息綜合交換,支持高速、實時、可控和可靠的信息實時傳輸?shù)於嘶A(chǔ),也為研究新一代綜合通信系統有重要意義。
[Abstract]:With the development of modern integrated electronic information system, the data transmission of real-time requirements more and more high, the traditional communication network has been unable to meet the demand, and the fiber channel (Fibre Channel FC) can support multiple transmission rates, various topology and multiple upper layer protocol, a high bandwidth embedded high-speed communication network, high the real-time, high reliability, high scalability solutions. But the FC core technology from foreign brocade and a few other manufacturers and the domestic monopoly, there is no unified standard of FC technology, especially in real-time security problem of FC network has no unified standard solution, to develop the independent controllable FC solutions. According to the security the technology of real-time FC network problems, combined with the technical feasibility, selection of optical fiber channel as the backbone network under certain network environment to carry on the research analysis and verification technology. The main work Has the following several aspects: 1, research on the fiber channel technology standards related to PCI protocol and Express bus protocol of fibre channel port type, transmission service type, network structure, IPFC protocol and PCI Express bus DMA control technology of.2, to study the technology of real-time FC network, from the real time the design of FC network interface card in two aspects of design and data packet scheduling priority high-speed transceiver design based on two aspects from the exchange and exchange priority support structure design of FC network is proposed to exchange real-time design.3, design of the FC network interface card and FC network switch scheme, principle diagram and hardware design, development and debugging. And complete the main realization and simulation verification of.4 based on FC network real-time FPGA technology, build a real-time test environment of FC network, FC network and FC network switch interface card The real-time function was tested, and the test results were analyzed. The test results show that the FC network interface, the design and implementation of the FC port rate is 2.125Gbps, the number of ports 2, support PCI-E * 4 channels, support the access of FC network communication ability, support IP over FC protocol mapping, meet the real-time requirements; FC network switch port rate 2.125Gbps, port number 12, the exchange capacity of not less than 24Gbps, the maximum switching delay is less than 30us.FC network interface card and FC network switch can meet the requirements of transmission function and the performance of the specific data of the FC network, to realize the multi network integration and information exchange, support high-speed, real-time, laid the foundation for the controllable reliable and real-time information transmission, but also for the study of a new generation of integrated communication system is of great significance.

【學位授予單位】：電子科技大學
【學位級別】：碩士
【學位授予年份】：2014
【分類號】：TN929.11

【參考文獻】

中國期刊全文數據庫 前2條

1 鄂大偉;基于多FIFO輸入隊列交換結構的迭代匹配算法性能分析與比較[J];計算機工程與應用;2001年11期

2 龐斌,賀思敏,高文;高速IP路由器中輸入排隊調度算法綜述[J];軟件學報;2003年05期

，

本文編號：1666997