蘇53區塊南水平井開發井網優化研究
發布時間：2018-10-23 18:25
【摘要】：蘇53區塊南部構造位于鄂爾多斯盆地伊陜斜坡北部中帶,主體構造為西北傾的單斜構造,目的層盒8段及山1段分別為辮狀河沉積和曲流河沉積,儲集體為心灘、邊灘和河道砂,是控制蘇53區塊南部地區有利區的主要微相。平面上砂體成北西-南東條帶狀分布,局部連片;垂向上有效砂體疊瓦狀分布,側向連續性差,造成氣藏分布的復雜性及儲層非均質性強。通過儲層建模相關認識,結合地應力和天然微裂縫發育情況預測了有效儲集砂體分布規律,在此基礎上利用地震屬性預測有利含氣區。研究區砂體總體呈現連片分布,其中,中、西部(蘇53-3、蘇53-4)地區砂體累積厚度較大,最大超過30米,東部(蘇53-8)地區累積厚度不足3米,含氣有利區和砂體厚度分布有較好的一致性。根據蘇里格地區“一點法”產能經驗公式,計算得出38口水平井平均產能44×104m3/d;利用物質平衡法、生產動態分析法、雙對數擬合法等9種方法對水平井進行了試采動態特征分析,預測了目前38口水平井平均單井井控動態儲量7039×104m3,通過建立各井井控動態儲量的預測圖版,得出研究區平均單井最終井控動態儲量12391×104m3。蘇53區塊南部地區通過數值模擬,認為合理水平段長度應控制在800~1000m之間,水平井的方位與地層主應力垂直,即為350°左右,通過壓恢試井解釋、經濟極限井網密度、合理采氣速度、儲量豐度、等效滲流計算及數值模擬結果,綜合認為合理井距為600~800m。根據儲層砂體分布特點采用近似菱形的不規則井網,井排間井點交叉分布。通過對井網方式、井網與地應力的關系、井距、水平井設計參數、產能、井控動態儲量這幾方面全面的綜合分析,認為目前水平井井網與氣藏地質具有較好的適應性,達到了水平井開發的技術經濟要求。
[Abstract]:The southern part of Su53 block is located in the northern middle belt of the Yishan slope in Ordos Basin. The main structure is a northwestern monoclinic structure, the target layer 8 member and the Shan 1 member are braided river deposits and meandering river deposits respectively, and the reservoir body is the core beach. The beach and channel sand are the main microfacies controlling the favorable area in the southern part of Su53 block. The sand bodies on the plane are distributed in the north west south east strip and the vertical effective sand bodies are imbricate distribution with poor lateral continuity which leads to the complexity of the gas reservoir distribution and the strong heterogeneity of the reservoir. Based on the understanding of reservoir modeling and combining with the development of in-situ stress and natural micro-fractures, the distribution law of effective reservoir sand bodies is predicted. On this basis, favorable gas-bearing areas are predicted by seismic attributes. The sand bodies in the study area generally show a continuous distribution. In the west (Su 53-3, Su 53-4), the accumulated thickness of the sand body is larger, the maximum is more than 30 meters, and the accumulated thickness in the east (Su 53-8) is less than 3 meters. There is good consistency between the thickness distribution of gas bearing favorable zone and sand body. According to the empirical formula of "one point method" productivity in Sulige area, the average productivity of 38 horizontal wells was calculated and obtained, and 9 methods, such as material balance method, production dynamic analysis method and double logarithm fitting method, were used to analyze the performance characteristics of horizontal wells. The average single well controlled reserves of 38 horizontal wells at present are predicted at 7039 脳 10 ~ 4m ~ (3). By establishing the prediction chart of each well's control performance reserves, it is obtained that the average final well control performance reserves in the study area are 12391 脳 10 ~ (4) m ~ (3). Through numerical simulation in the southern area of Su53 block, it is considered that the reasonable horizontal section length should be controlled between 800m and 1000m, and the orientation of horizontal well should be vertical to the main stress of formation, that is, 350 擄. The economic limit well pattern density can be explained by pressure recovery well test. The reasonable gas production rate, reserve abundance, equivalent seepage calculation and numerical simulation results show that the reasonable well spacing is 600 ~ 800m. According to the distribution characteristics of reservoir sand body, the irregular well pattern is approximately rhombic, and the cross distribution of well points between rows is adopted. Through comprehensive analysis of well pattern mode, the relationship between well pattern and ground stress, well spacing, horizontal well design parameters, productivity, well control dynamic reserves, it is concluded that the horizontal well pattern has good adaptability to gas reservoir geology. Meet the technical and economic requirements of horizontal well development.
【學位授予單位】：東北石油大學
【學位級別】：碩士
【學位授予年份】：2017
【分類號】：TE243
，
本文編號：2290099
[Abstract]:The southern part of Su53 block is located in the northern middle belt of the Yishan slope in Ordos Basin. The main structure is a northwestern monoclinic structure, the target layer 8 member and the Shan 1 member are braided river deposits and meandering river deposits respectively, and the reservoir body is the core beach. The beach and channel sand are the main microfacies controlling the favorable area in the southern part of Su53 block. The sand bodies on the plane are distributed in the north west south east strip and the vertical effective sand bodies are imbricate distribution with poor lateral continuity which leads to the complexity of the gas reservoir distribution and the strong heterogeneity of the reservoir. Based on the understanding of reservoir modeling and combining with the development of in-situ stress and natural micro-fractures, the distribution law of effective reservoir sand bodies is predicted. On this basis, favorable gas-bearing areas are predicted by seismic attributes. The sand bodies in the study area generally show a continuous distribution. In the west (Su 53-3, Su 53-4), the accumulated thickness of the sand body is larger, the maximum is more than 30 meters, and the accumulated thickness in the east (Su 53-8) is less than 3 meters. There is good consistency between the thickness distribution of gas bearing favorable zone and sand body. According to the empirical formula of "one point method" productivity in Sulige area, the average productivity of 38 horizontal wells was calculated and obtained, and 9 methods, such as material balance method, production dynamic analysis method and double logarithm fitting method, were used to analyze the performance characteristics of horizontal wells. The average single well controlled reserves of 38 horizontal wells at present are predicted at 7039 脳 10 ~ 4m ~ (3). By establishing the prediction chart of each well's control performance reserves, it is obtained that the average final well control performance reserves in the study area are 12391 脳 10 ~ (4) m ~ (3). Through numerical simulation in the southern area of Su53 block, it is considered that the reasonable horizontal section length should be controlled between 800m and 1000m, and the orientation of horizontal well should be vertical to the main stress of formation, that is, 350 擄. The economic limit well pattern density can be explained by pressure recovery well test. The reasonable gas production rate, reserve abundance, equivalent seepage calculation and numerical simulation results show that the reasonable well spacing is 600 ~ 800m. According to the distribution characteristics of reservoir sand body, the irregular well pattern is approximately rhombic, and the cross distribution of well points between rows is adopted. Through comprehensive analysis of well pattern mode, the relationship between well pattern and ground stress, well spacing, horizontal well design parameters, productivity, well control dynamic reserves, it is concluded that the horizontal well pattern has good adaptability to gas reservoir geology. Meet the technical and economic requirements of horizontal well development.
【學位授予單位】：東北石油大學
【學位級別】：碩士
【學位授予年份】：2017
【分類號】：TE243
，
本文編號：2290099
本文鏈接：http://sikaile.net/kejilunwen/shiyounenyuanlunwen/2290099.html
教材專著
