本文選題：活性材料　切入點：壓縮特性　出處：《北京理工大學學報》2017年04期

【摘要】：采用準靜態壓縮實驗的方法,對冷壓成型PTFE/Al/W活性材料的力學特性進行了研究.基于準靜態應力-應變曲線分析,得到了活性材料密度對抗壓強度和楊氏模量的影響規律.結果表明,隨著活性材料密度的提高,抗壓強度和楊氏模量呈逐漸增大趨勢,材料失效裂紋與軸線基本呈30°~45°角.進一步對準靜態壓縮前、后活性材料試樣細觀結構電鏡掃描分析發現,在一定密度范圍內,隨著基體材料含量的減少和活性材料密度的提高,準靜態壓縮載荷作用下材料內部形成的力鏈數量隨之增加,從而導致活性材料抗壓強度和楊氏模量的增大.
[Abstract]:The mechanical properties of PTFE/Al/W active materials formed by cold pressing were studied by quasi static compression test.Based on the analysis of quasi-static stress-strain curves, the influence of the density of active materials on the compressive strength and Young's modulus is obtained.The results show that the compressive strength and Young's modulus increase gradually with the increase of the density of the active material, and the failure crack and the axis of the material show an angle of 30 擄to 45 擄.Before and after static compression, it was found that in a certain range of density, with the decrease of matrix material content and the increase of active material density,The number of internal force chains formed under quasi-static compression load increases, which leads to the increase of compressive strength and Young's modulus of the active materials.
【作者單位】： 北京理工大學爆炸科學與技術國家重點實驗室;
【基金】：國家自然科學基金資助項目(11202030)
【分類號】：TB301
，

本文編號：1725633