基于DSP的煤礦井下電能質量在線檢測系統
[Abstract]:In coal mine work, output and efficiency are very important. As industrial automation has been used in mine operations, the collection of coal is now covered with electronic instruments. This modern service has greatly facilitated the mining industry. With a large number of nonlinear loads connected to the coal power network, the power quality of the coal power network has been reduced, and the power quality will be measured by a very high standard when the coal mine detects the connected nonlinear load. Therefore, people now put forward a very high demand for the power quality of coal mine electricity. In this paper, the system architecture of nonlinear charge detection is composed of digital signal processor and complex programmable logic device. The system is based on a digital signal processor. This system not only can detect nonlinear load, but also can detect related parameters of other kinds of electric energy. For example, voltage and current can be effectively detected. The device also adds a number of other features, such as a regular validity record at a particular point in time. At the same time, it can support the expansion of SD card interface, which is also very helpful for the system to access data. The communication mode of the system can be divided into RS485 local communication and Ethernet remote communication. In these two communication modes, RS485 can help users digitally manage the statistical data, while the network interface can make the data transmit directly. This paper mainly introduces the following parts: firstly, it introduces the technology and reality of power quality measurement at home and abroad, and then gives a brief introduction to the measuring methods of power quality related parameters. After that, the hardware design and software design of the system are introduced. Finally, through the detection of the system to prove the effectiveness of the device. Finally, the performance of the system is tested, and some mechanisms in operation are explained. In the final system test, it can be concluded that the detection function of this device is powerful and has high precision. And the device has many additional functions, can help users to get a better use of experience. Therefore, the device is highly competitive in the market.
【學位授予單位】:安徽理工大學
【學位級別】:碩士
【學位授予年份】:2015
【分類號】:TD611
【參考文獻】
相關期刊論文 前10條
1 黃方能;黃成軍;陳陳;江秀臣;;高精度插值FFT諧波分析[J];電力自動化設備;2007年09期
2 林海雪;;電能質量國家標準介紹[J];電氣工程應用;2005年01期
3 彭明智;劉永強;;基于DSP和MCU的電能質量在線監測裝置的設計[J];電氣自動化;2010年02期
4 胡銘,陳珩;電能質量及其分析方法綜述[J];電網技術;2000年02期
5 肖湘寧,徐永海;電能質量問題剖析[J];電網技術;2001年03期
6 王海燕;楊平;王志萍;;基于GPRS技術的電能質量在線監測系統[J];低壓電器;2010年19期
7 潘曉杰;劉滌塵;鄒江峰;;基于DSP的電能質量在線監測裝置[J];高電壓技術;2005年12期
8 劉書明 ,聶麗斌 ,余愛民;ADS8364的原理及應用[J];國外電子元器件;2002年10期
9 佟為明;金顯吉;盧雷;李鳳閣;;基于DSP的網絡型電能質量監測裝置[J];低壓電器;2013年03期
10 錢昊;趙榮祥;;電力系統中諧波分析的高精度FFT算法[J];江南大學學報;2006年05期
相關博士學位論文 前1條
1 何順帆;實時電能質量分析理論與技術的研究[D];華中科技大學;2013年
,本文編號:2412373
本文鏈接:http://sikaile.net/kejilunwen/kuangye/2412373.html