本文選題：APAM + 全尾砂��； 參考：《中國有色金屬學報》2017年02期

【摘要】：以某鉛鋅銀礦全尾砂沉降試驗為例,分析添加不同絮凝劑單耗時,全尾砂漿渾液面沉速的變化規律,旨在探究3個不同沉降階段的機理。結果表明:隨添加相對分子質量為8×10~6的陰離子聚丙烯酰胺(APAM)單耗的增加,1 min內全尾砂漿的渾液面沉速先增加后減小;在加速自由沉降段,游離的"細"顆粒尾砂及過多的絮團水影響了渾液面沉速;在干涉沉降段,空間位阻效應導致的尾砂顆粒間互相排斥降低了渾液面沉速;在壓縮沉降段,孔隙水減少及絮團水增加改變界面沉速;絮凝劑單耗0、10、20、30和40 g/t分別表示無、低、合理、高和超量。
[Abstract]:Taking the whole tailings settlement test of a lead-zinc silver mine as an example, this paper analyzes the variation law of settling velocity of muddy liquid surface with different flocculant single time consuming and full tail mortar, in order to explore the mechanism of three different settling stages. The results show that with the increase of unit consumption of anionic polyacrylamide (APAM) with relative molecular weight of 8 脳 10 ~ (6), the settling velocity of muddy liquid surface of full-tail mortar firstly increases and then decreases in 1 min. Free "fine" particle tailings and excessive floc water affect the settling velocity of muddy liquid surface; in the interference settlement section, the velocity of settling of muddy liquid surface is reduced by mutual exclusion between the particles caused by the spatial steric resistance effect; in the compression settlement section, the settling speed of muddy liquid surface is reduced by the free "fine" particle tailings and too much floc water. The decrease of pore water and the increase of flocculation water change the interfacial sedimentation rate, and the flocculant consumption of 0 10% 20% 30 and 40 g / t respectively means no, low, reasonable, high and excess.
【作者單位】： 中南大學資源與安全工程學院;
【基金】：國家“十二五”科技支撐計劃資助項目(2013BAB02B05)~~
【分類號】：TD853.34

【參考文獻】

相關期刊論文 前10條

1 牟宏偉;呂文生;李樹磊;車賽杰;;絮凝劑在膠結充填應用中的試驗研究[J];礦冶;2016年01期

2 吳愛祥;周靚;尹升華;王雷鳴;;全尾砂絮凝沉降的影響因素[J];中國有色金屬學報;2016年02期

3 王新民;趙建文;張德明;;全尾砂絮凝沉降速度優化預測模型[J];中國有色金屬學報;2015年03期

4 王勇;吳愛祥;王洪江;劉斯忠;周勃;;絮凝劑用量對尾礦濃密的影響機理[J];北京科技大學學報;2013年11期

5 康英俊;鞏君放;;超細全尾砂連續充填工藝技術的研究與開發[J];價值工程;2013年32期

6 林繼輝;王春萍;姚小梅;吳陽;;不同相對分子質量的APAM的制備及其動力黏度性質研究[J];云南民族大學學報(自然科學版);2013年02期

7 金磊;王可;葉一蘭;上官勇剛;安全福;江志平;鄭強;;聚丙烯酰胺絮凝效果的母液濃度依賴性及其影響[J];高分子學報;2012年03期

8 Chinthapudi Eswaraiah;Surendra Kumar Biswal;Barada Kanta Mishra;;Settling characteristics of ultrafine iron ore slimes[J];International Journal of Minerals Metallurgy and Materials;2012年02期

9 ;Effect of viscosity,basicity and organic content of composite flocculant on the decolorization performance and mechanism for reactive dyeing wastewater[J];Journal of Environmental Sciences;2011年10期

10 焦華U，

本文編號：2053507