堅硬特厚煤層頂煤冒放結構及提高采出率技術
本文選題:堅硬特厚煤層 + 大采高綜放。 參考:《煤炭學報》2017年04期
【摘要】:針對西部埋深較淺、堅硬、特厚煤層頂煤冒放性差的問題,以金雞灘煤礦2-2上堅硬特厚煤層賦存條件為基礎,通過理論模型計算、數值模擬分析及設備結構優化設計等方法,分析了堅硬特厚煤層頂煤冒放結構及提高采出率技術。通過建立堅硬特厚頂煤的"懸臂梁"力學模型,計算分析了頂煤厚度與懸臂極限斷裂長度的關系;首次定量分析了液壓支架反復支撐對頂煤的損傷破壞效果,研究了液壓支架主動支護作用力、反復支撐次數對頂煤破壞深度、破壞塊度的影響;分析了大采高綜放工作面煤壁片幫防治與提高頂煤冒放性的矛盾,通過優化液壓支架架型結構參數解決了二者之間的矛盾;創新設計了強擾動三級高效放煤機構與綜放工作面后部刮板輸送機交叉?zhèn)刃恫贾梅绞?有效提高了大塊頂煤的放出率與放出效率。
[Abstract]:Aiming at the problem of shallow buried depth, hard coal seam and poor caving ability of top coal seam in the west of China, based on the occurrence conditions of hard and super thick coal seam on 2-2 of Jinjitan Coal Mine, the methods of theoretical model calculation, numerical simulation analysis and equipment structure optimization design are adopted. The caving structure of top coal in hard and thick coal seam and the technology of improving mining rate are analyzed. By establishing the "cantilever beam" mechanical model of hard and super thick top coal, the relationship between the thickness of top coal and the limit fracture length of cantilever is calculated and analyzed, and the damage and failure effect of repeated support of hydraulic support on top coal is quantitatively analyzed for the first time. This paper studies the influence of active support force of hydraulic support and the times of repeated support on the failure depth and fragmentation of top coal, and analyzes the contradiction between prevention and cure of coal wall and the improvement of caving property of top coal in fully mechanized top-coal caving face with high mining height. By optimizing the structural parameters of hydraulic support frame, the contradiction between them is solved, and the cross side unloading arrangement of strong disturbance three stage high efficiency caving mechanism and the rear scraper conveyor of fully mechanized caving face is designed. The extraction rate and efficiency of bulk top coal are improved effectively.
【作者單位】: 天地科技股份有限公司開采設計事業部;煤炭科學研究總院開采研究分院;
【基金】:國家重點基礎研究發展計劃(973)資助項目(2014CB046302) 青年創新基金資助項目(2016QN007)
【分類號】:TD823;TD355.4
【參考文獻】
相關期刊論文 前10條
1 解興智;趙鐵林;;淺埋堅硬特厚煤層綜放開采頂煤冒放結構分析[J];煤炭學報;2016年02期
2 殷帥峰;何富連;程根銀;;大采高綜放面煤壁片幫判定準則及安全評價系統研究[J];中國礦業大學學報;2015年05期
3 龐義輝;劉新華;馬英;;千萬噸礦井群綜放智能化開采設備關鍵技術[J];煤炭科學技術;2015年08期
4 Jiachen Wang;Jinwang Zhang;Zhengyang Song;Zhaolong Li;;Three-dimensional experimental study of loose top-coal drawing law for longwall top-coal caving mining technology[J];Journal of Rock Mechanics and Geotechnical Engineering;2015年03期
5 鄧雪杰;張吉雄;黃鵬;張強;郝雄飛;;特厚煤層上向分層充填開采頂板移動特征分析[J];煤炭學報;2015年05期
6 黃慶享;劉建浩;;淺埋大采高工作面煤壁片幫的柱條模型分析[J];采礦與安全工程學報;2015年02期
7 王家臣;張錦旺;;綜放開采頂煤放出規律的BBR研究[J];煤炭學報;2015年03期
8 王國法;龐義輝;;液壓支架與圍巖耦合關系及應用[J];煤炭學報;2015年01期
9 王國法;;煤炭綜合機械化開采技術與裝備發展[J];煤炭科學技術;2013年09期
10 張西斌;周剛;劉志文;樊虎子;王波;孫越;;特厚煤層分層綜放開采工藝技術研究[J];煤炭科學技術;2013年07期
【共引文獻】
相關期刊論文 前10條
1 郭彬;;千萬噸級礦井集群生態圈構建及管理優化研究[J];科技進步與對策;2017年09期
2 張宏偉;周坤友;榮海;付興;趙象卓;;淺埋深大采高工作面礦壓顯現及支架適應性研究[J];煤炭科學技術;2017年04期
3 龐義輝;王國法;;堅硬特厚煤層頂煤冒放結構及提高采出率技術[J];煤炭學報;2017年04期
4 王金華;黃志增;于雷;;特厚煤層綜放開采頂煤體“三帶”放煤理論與應用[J];煤炭學報;2017年04期
5 王玉成;;基于膏體充填的氣體充填開采頂板移動特征分析[J];內蒙古煤炭經濟;2017年07期
6 楊世力;宋選民;周鈺博;王大威;;含硬夾矸大采高仰采綜放面煤壁穩定性機理研究[J];煤礦開采;2017年02期
7 劉長友;;綜放開采理論與技術的發展及思考[J];同煤科技;2017年02期
8 胡q,
本文編號:1838350
本文鏈接:http://sikaile.net/kejilunwen/kuangye/1838350.html