本文選題：煤的成塊率 + 煤的動態特性��； 參考：《安徽理工大學》2017年碩士論文

【摘要】：我國西部煤炭儲量豐富,是目前煤炭生產的主產地。然而,由于其成煤特性和生產工藝(包括綜采、機運、轉載等)的影響和作用,到達用戶時原煤較為破碎,粉煤多、成塊率低,嚴重制約了煤炭的使用價值。鑒于此,人們已著手進行各方面的研究,意欲提高原煤的成塊率,煤層內超長深孔爆破是為有效技術手段之一,研究煤的動態力學性質是其基礎。為此,論文以楊伙盤礦煤的原煤為例,采用實驗室沖擊試驗和數值模擬相結合,進行煤的沖擊動態力學特性研究。利用分離式霍普金森壓桿(SHPB)實驗裝置,采用Φ50mm錐形桿對煤進行沖擊試驗,探究不同氣壓(0.15MPa、0.20MPa、0.30MPa、0.40MPa、0.50MPa)下煤的動態力學特性。試驗分別在無圍壓和被動圍壓下進行,速度為2m/s～7m/s。通過采集到的數據,用三波法得到應力、應變和應變率;再用數據處理軟件進行處理分析得獲得了應力、應變和應變率時程曲線以及應力-應變曲線。實驗結果表明:(1)應變率和加載速度相關性明顯,通過擬合得到ε=3.750v2-3.624v + 43;隨著加載速度的增加,應力-應變曲線整體上升,曲線在加載初期,存在短時間的彈性階段,之后呈現明顯的塑形變形,達到峰值以后,在很短的時間內,應變繼續增加,應力保持不變,最后進入卸載階段,應變會出現回彈現象;(2)被動圍壓下,煤的抗破壞能力有所增強,應力-應變曲線有所上升,軸向應力比無圍壓下增加1.0～1.3倍,應變回彈明顯,說明套筒可以增強煤試件的抗變形能力。利用ANSYS/LS-DYNA對煤的動態力學性質進行模擬,結果以發現煤的破壞從兩端和中間開始,并逐漸貫通,直至破碎。整合數值模擬的應力與應變數據,得到煤的動態應力-應變曲線,相應的加載速度為3m/s、4m/s、5m/s和6m/s。通過比較,該應力與應變的變化趨勢與實驗曲線吻合,從而證明了實驗的正確性。
[Abstract]:The west of China is rich in coal reserves and is the main producing area of coal production at present. However, due to the influence and effect of coal forming characteristics and production technology (including fully mechanized coal mining, mechanical transportation, reloading, etc.), the raw coal is more broken, the pulverized coal is more, and the lump rate is low, which seriously restricts the use value of coal. In view of this, people have begun to carry out various aspects of research, with the intention to improve the block rate of raw coal, the ultra-long deep-hole blasting in coal seam is one of the effective technical means, and the study of dynamic mechanical properties of coal is its basis. Therefore, taking the raw coal of Yangyangpan Coal Mine as an example, the dynamic mechanical properties of coal impact are studied by combining the laboratory impact test with numerical simulation. In this paper, the impact test of coal with 桅 50mm conical rod was carried out by using split Hopkinson pressure bar SHPB. the dynamic mechanical properties of coal under different pressure of 0.15 MPA ~ 0.20 MPA ~ 0.30 MPA ~ 0.40 MPa ~ (0. 50 MPA ~ (-1) were investigated. The experiments were carried out at a speed of 2 m / s to 7 m / s under no confining pressure and passive confining pressure respectively. The stress, strain and strain rate are obtained by three wave method, and the stress, strain and strain rate time history curves and stress-strain curves are obtained by data processing software. The experimental results show that the strain rate has obvious correlation with the loading speed, and the fitting results show that 蔚 = 3.750v2-3.624v 43. With the increase of loading speed, the stress-strain curve increases as a whole, and the curve has a short elastic stage in the early stage of loading. The strain continues to increase in a very short period of time, and the stress remains unchanged. Finally, when the strain enters the unloading stage, the strain will appear springback under passive confining pressure. The failure resistance of coal is enhanced, the stress-strain curve is increased, the axial stress is increased by 1.0 ~ 1.3 times than that without confining pressure, and the strain springback is obvious, which indicates that the sleeve can enhance the deformation resistance of the coal specimen. The dynamic mechanical properties of coal are simulated by ANSYS/LS-DYNA. The results show that the destruction of coal starts from the two ends and the middle, and goes through gradually until it is broken. The dynamic stress-strain curves of coal are obtained by integrating the stress and strain data of numerical simulation. The corresponding loading speeds are 3 m / s ~ 4 m / s ~ 4 m / s ~ 5 m / s and 6 m / s / s. By comparison, the variation trend of the stress and strain is in agreement with the experimental curve, which proves the correctness of the experiment.
【學位授予單位】：安徽理工大學
【學位級別】：碩士
【學位授予年份】：2017
【分類號】：TD315

【參考文獻】

相關期刊論文 前10條

1 馬文偉;趙光明;孟祥瑞;韓東波;;沖擊載荷下砂巖強度特性及破壞規律研究[J];地下空間與工程學報;2016年02期

2 付玉凱;解北京;王啟飛;;煤的動態力學本構模型[J];煤炭學報;2013年10期

3 解北京;崔永國;王金貴;;煤沖擊破壞力學特性試驗研究[J];煤礦安全;2013年11期

4 袁璞;馬芹永;;干濕循環條件下煤礦砂巖分離式霍普金森壓桿試驗研究[J];巖土力學;2013年09期

5 高文蛟;單仁亮;蘇永強;;無煙煤單軸沖擊動態強度理論[J];爆炸與沖擊;2013年03期

6 朱晶晶;李夕兵;宮鳳強;王世鳴;;單軸循環沖擊下巖石的動力學特性及其損傷模型研究[J];巖土工程學報;2013年03期

7 劉曉輝;張茹;劉建鋒;;不同應變率下煤巖沖擊動力試驗研究[J];煤炭學報;2012年09期

8 高文蛟;單仁亮;;無煙煤在沖擊載荷下破壞模式與強度特性[J];煤炭學報;2012年S1期

9 巫緒濤;李耀;李和平;;混凝土HJC本構模型參數的研究[J];應用力學學報;2010年02期

10 李勝林;劉殿書;李祥龍;康后金;王立彬;;Ф75mm分離式霍普金森壓桿試件長度效應的試驗研究[J];中國礦業大學學報;2010年01期

相關博士學位論文 前2條

1 張文清;沖擊載荷下松軟煤力學特性及對煤與瓦斯突出的影響[D];安徽理工大學;2015年

2 胡柳青;沖擊載荷作用下巖石動態斷裂過程機理研究[D];中南大學;2005年

相關碩士學位論文 前1條

1 高科;巖石SHPB實驗技術數值模擬分析[D];中南大學;2009年

，

本文編號：1827401