本文選題：校正平均角法 + 測斜�。� 參考：《中國礦業》2017年01期

【摘要】：為了準確掌握深部巖體鉆孔的偏斜情況。采用現場測試和理論分析的方法,以新疆伽師銅礦項目為依托,借助EXCEL編輯校正平均角法公式,處理現場實測數據,利用CAD繪制鉆孔傾斜平面圖及縱斷面透視圖,分析深部鉆孔質量并提出相應的對策。研究表明:現場采用KXP-2D小孔徑羅盤測斜儀進行鉆孔測斜,可測得較為準確的數據。由于礦體自身穩定性差,鉆孔深度較深,導致鉆孔偏斜角度較大,且鉆孔偏斜角隨著鉆孔深度的增加不斷增大,鉆孔深度超過25m,鉆孔底部出現塌孔的現象,其中5排和6排的鉆孔鉆進圍巖中,影響鉆孔的質量。因此,對于鉆孔鉆進圍巖的礦體,按照潛孔鑿巖爆破法開采,對于在礦體內的鉆孔采用VCR法,以滿足采礦過程中安全性和經濟性的要求。
[Abstract]:In order to accurately understand the deflection of deep rock drilling. Based on the project of Jiashi Copper Mine in Xinjiang, this paper adopts the method of field test and theoretical analysis, with the help of EXCEL to edit the formula of correction average angle, to deal with the field measured data, and to use CAD to draw the borehole inclined plane map and the vertical section perspective view. The quality of deep drilling is analyzed and the corresponding countermeasures are put forward. The results show that the KXP-2D small aperture compass inclinometer can be used to measure the deviation of borehole and obtain more accurate data. Because of the poor stability of the orebody itself and the deep depth of the borehole, the borehole deflection angle is larger, and the borehole deflection angle increases with the increase of the borehole depth, the borehole depth exceeds 25m, and the hole collapses at the bottom of the borehole. Among them, 5 rows and 6 rows of boreholes are drilled into surrounding rock, which affects the quality of drilling. Therefore, in order to meet the requirements of safety and economy in mining process, VCR method is used for drilling in the surrounding rock, and for drilling in the body of the mine, according to the method of downhole drilling and blasting.
【作者單位】： 伽師縣銅輝礦業有限責任公司;北京科技大學土木與環境工程學院;
【基金】：國家“十二五”科技支撐計劃項目資助(編號:2012BAB08B02) 國家自然科學基金項目資助(編號:51304011;50934002) 中央高�；究蒲袠I(yè)務費專項資金項目資助(編號:FRF-TP-15-044A2)
【分類號】：TD862.1

【相似文獻】

相關期刊論文 前3條

1 向軍文;;關于定向井?dāng)?shù)據的精確處理問題探討[J];探礦工程(巖土鉆掘工程);2007年09期

2 向軍文;;對接連通井及定向鉆井軌跡設計[J];科技創新導報;2010年27期

3 ;[J];;年期

，

本文編號：1792710