發布時間：2018-06-04 01:53

  本文選題：軸流壓氣機 + 反葉片角向縫機匣處理��； 參考：《航空動力學報》2016年10期

【摘要】：采用試驗和非定常數值模擬方法研究了反葉片角向縫機匣處理對亞聲速軸流壓氣機性能的影響.試驗與數值計算結果均指出反葉片角向縫機匣處理后,轉子在降低12%左右最大等熵效率的基礎上獲得30.1%左右的失速裕度改進量.詳細的轉子葉頂流場分析表明反葉片角向縫機匣處理改善了葉頂間隙泄漏流動,消除了實體壁機匣時葉頂通道低速泄漏流形成的堵塞,因此轉子穩定性得以提高.同時轉子葉片與處理縫的相對位置變化會影響處理縫的擴穩能力.處理縫中回流、處理縫形成的噴射流與葉頂通道主流的相互作用都造成較大的流動損失,進而使轉子等熵效率降低.反葉片角向縫機匣處理前移約55%葉頂軸向弦長的數值研究結果表明,與反葉片角向縫機匣處理比較,反葉片角向縫機匣處理前移獲得的失速裕度改進量降低約10.4%,但等熵效率的惡化程度降低近64%.
[Abstract]:The effect of reverse blade angular slot casing treatment on the performance of subsonic axial flow compressor was studied by means of experimental and unsteady numerical simulation. The experimental and numerical results show that the rotor can reduce the maximum isentropic efficiency by about 12% and obtain a stall margin improvement of about 30.1% after the reverse blade angular slot casing is treated. Detailed analysis of rotor blade tip flow field shows that the reverse blade angular slot casing treatment improves the tip clearance leakage flow and eliminates the clogging of the low speed leakage flow in the blade top channel during the solid wall casing, so the rotor stability can be improved. At the same time, the relative position of the rotor blade and the treated joint will affect the stability of the treated joint. The flow loss caused by the jet flow formed by the treatment slot and the interaction between the jet flow formed by the treatment seam and the mainstream of the vane channel resulted in a decrease in the rotor Isentropic efficiency. The results of numerical study on the axial chord length of the blade tip of about 55% forward displacement of the reverse blade angular slot casing treatment show that, compared with the reverse blade angle joint casing treatment, The improvement of stall margin obtained by backward blade angle-slotted casing treatment decreases about 10.4 percent, but the deterioration of Isentropic efficiency is reduced by nearly 64 percent.
【作者單位】： 西北工業大學動力與能源學院;先進航空發動機協同創新中心;
【基金】：國家自然科學基金(51006084) 航空科學基金(2014ZB53014) 中央高校基本科研業務專項資金(3102014JCY01004) 陜西省自然科學基金(2015JM5202)
【分類號】：TH453

【相似文獻】

相關期刊論文 前10條

1 張皓光;楚武利;吳艷輝;鄧文劍;張夏;;吹氣型周向槽機匣處理擴穩機理的研究[J];航空動力學報;2007年06期

2 屠寶鋒;胡駿;王永明;;機匣處理的非定常數值分析[J];航空動力學報;2007年09期

3 吳艷輝;張皓光;楚武利;蘇中亮;;雙級跨音風扇軸向縫處理機匣結構優化的數值研究[J];西北工業大學學報;2010年02期

4 黃磊;余華蔚;吳艷輝;;單級跨聲風扇處理機匣徑向傾角變化對性能的影響[J];燃?xì)鉁u輪試驗與研究;2011年04期

5 李克明,趙全春,孫元楹;機匣處理對軸流式壓氣機性能的影響[J];工程熱物理學報;1981年03期

6 劉志偉;張長生;時靜s，

本文編號：1975307