本文選題：螺旋升降機　切入點：絲杠螺母副　出處：《組合機床與自動化加工技術》2016年04期

【摘要】：利用Gallina二自由度模型對螺旋升降機在下降過程中發出的異響聲和振動進行研究。指出由于螺旋升降機的慣性矩陣是非對稱矩陣,所以垂向平動和繞鉛垂軸轉動存在非對稱的耦合現象。同時,研究表明慣性矩陣的非對稱性是造成系統自激振動的主要原因,并得出了螺旋升降機動力學穩定性的判定依據。結合某螺旋升降機的參數,利用Math CAD分別得到了摩擦系數、絲杠中徑和軸向載荷對系統穩定性影響的曲線,并提出了避免螺旋升降機自激振動的措施。
[Abstract]:Using Gallina two-degree-of-freedom model, the abnormal sound and vibration of helical hoist during descent are studied. It is pointed out that the inertia matrix of helical elevator is asymmetric matrix. Therefore, there is asymmetric coupling between vertical translation and rotation around the vertical axis. At the same time, the study shows that the asymmetry of inertial matrix is the main cause of the self-excited vibration of the system. According to the parameters of a screw lift, the influence curves of friction coefficient, central diameter of lead screw and axial load on the stability of the system are obtained by Math CAD. The measures to avoid self-excited vibration of screw lift are put forward.
【作者單位】： 電子科技大學機械電子工程學院;
【基金】：國家自然科學基金項目(51405067)
【分類號】：TH211.6

【相似文獻】

相關期刊論文 前10條

1 楊憲武;左曙光;雷鐳;吳旭東;李勇;;輪胎自激振動分岔參數影響分析[J];振動與沖擊;2012年02期

2 余承業;切削金屬時消除自激振動的新方法[J];南京航空航天大學學報;1957年01期

3 程高楣;;關于切削加工時自激振動產生的基本理論[J];太原工學院學報;1957年01期

4 慔明;齒，

本文編號：1690970