本文關鍵詞：AFM測試參數對等高粗糙表面黏著影響的實驗研究　出處：《潤滑與密封》2016年05期 　論文類型：期刊論文

  更多相關文章： 等高粗糙 硅光柵 AFM 黏著 平頭探針

【摘要】：采用具有600 nm周期的一維硅光柵來表示等高粗糙表面,研究AFM的測試參數對等高粗糙表面的黏著影響。實驗所使用的探針為平頭探針(PL2-CONTR-10,Nanosensors),其針尖直徑為2μm,實驗分別在空氣中以及干燥環境下進行,通過力曲線的測量,計算出黏著力的平均值以及標準差。結果表明:載荷與停留時間會引起黏著力的略微增大或減小,但總體影響不是很大;在空氣中,隨著退針?biāo)俾始涌?黏著力先表現出先增大然后減小的趨勢;而在干燥環境下,黏著力隨著退針?biāo)俾实募涌熘饾u減小。
[Abstract]:A one-dimensional silicon grating with a period of 600 nm is used to represent the equi-high rough surface. The influence of AFM parameters on the adhesion of rough surface was studied. The probe used in the experiment was PL2-CONTR-10 Nanosensors. The diameter of the tip was 2 渭 m. The experiment was carried out in air and dry environment, and the force curve was measured. The average value and standard deviation of the adhesion force are calculated. The results show that the load and residence time will cause a slight increase or decrease of the adhesion force, but the overall effect is not very great. In the air, the adhesive force increases first and then decreases with the increase of the speed of needle withdrawal. In the dry environment, the adhesive force decreases with the increase of the speed of needle withdrawal.
【作者單位】： 華南理工大學機械與汽車工程學院;
【基金】：國家自然科學基金項目(51175182)
【分類號】：TH117
【正文快照】： )j縥縥縥縥縥縥，

本文編號：1377600