本文關鍵詞：并聯充電式混合動力驅動系統故障診斷分析儀開發　出處：《武漢理工大學》2011年碩士論文　論文類型：學位論文

  更多相關文章： 混合動力 驅動系統 診斷分析儀 觸摸屏 故障診斷

【摘要】：隨著全球汽車保有量的增加,石油的供應日趨緊張,石油資源的枯竭正在加劇,同時汽車排入大氣中的有害污染物導致空氣中有害污染物增加,環境污染問題日益嚴重,新能源汽車以其低能耗、低污染等特點成為當前各汽車企業和科研機構的研發熱點。 混合動力汽車以其低排放,低能耗,以及兼有傳統汽車和新能源汽車雙方的優點,引起各政府和各大汽車公司的關注。但是混合動力汽車控制系統和功能比傳統的汽車復雜很多,因此在混合動力汽車開發的過程中,其開發和調試診斷的成本、難度都高于傳統汽車。本文分析對比了幾種混合動力汽車的布置形式,在此基礎上提出了并聯充電式的混合動力系統的基本結構,并且對發動機、電機、變速箱、電池、整車控制單元等基本組成部件進行分析介紹。同時本文還研究了國內外混合動力汽車和汽車診斷的發展現狀,分析了各種汽車故障診斷方法,在對并聯充電式混合動力驅動系統進行詳細分析的基礎上,提出了適合合于充電式混合動力驅動系統的故障診斷儀的基本構架。在分析了診斷儀系統的基本需求后,對系統的軟件和硬件進行了選型,選擇PLC、EVIEW觸摸屏作為系統的硬件基礎,選擇EVIEW自帶的EV5000作為系統與混合動力驅動系統整車控制單元通訊程序和系統顯示、診斷界面的編程軟件。 根據系統的基本需求,分析了并聯充電式混合動力驅動系統可能出現的故障種類,并在整車控制單元的控制程序中編寫了相關的子程序?qū)赡艹霈F(xiàn)的故障進行了判斷,判斷后生成一個標志位信號,這個標志位和EVIEW中制作的故障指示界面中故障指示燈地址相同,這樣故障信號就從整車控制單元傳到觸摸屏中,同時設置驅動系統各參數在PLC中的地址和觸摸屏中的制作的顯示界面中的各元件的地址相同。通過這個通訊程序,就可以將系統各參數的實時狀態和出現的故障傳到EVIEW觸摸屏中,實現了對系統的實時監測和故障的報警。 實驗表明,診斷儀能夠?qū)︱?qū)動系統在啟動、加速、換檔、制動過程中各參數的狀態進行實時的顯示,并且在系統出現故障時能夠及時的在診斷界面提示報警,基本實現了對于并聯充電式混合動力驅動系統的故障診斷,并且為后續研究開發提供了必要的經驗。
[Abstract]:With the increase of global automobile ownership, the supply of oil is becoming increasingly tight, the depletion of oil resources is increasing, and the harmful pollutants emitted into the atmosphere by cars lead to the increase of harmful pollutants in the air. The problem of environmental pollution is becoming more and more serious. New energy vehicles have become the research and development hotspot of automobile enterprises and scientific research institutions because of its low energy consumption and low pollution. Hybrid vehicles (HEVs) have the advantages of low emissions, low energy consumption and both conventional and new energy vehicles. However, the control system and function of HEV are more complicated than the traditional vehicle, so in the process of development of HEV, the cost of development and debugging diagnosis of HEV is much higher. The difficulty is higher than the traditional vehicle. This paper analyzes and compares the layout of several hybrid electric vehicles, and puts forward the basic structure of the parallel charging hybrid power system, and the engine, motor. The basic components, such as gearbox, battery, vehicle control unit and so on, are analyzed and introduced. At the same time, the development status of hybrid electric vehicle and vehicle diagnosis at home and abroad is studied, and various vehicle fault diagnosis methods are analyzed. Based on the detailed analysis of the parallel charging hybrid drive system. The basic frame of fault diagnosis instrument suitable for charging hybrid drive system is put forward. After analyzing the basic requirements of diagnostic instrument system, the software and hardware of the system are selected and PLC is selected. The EVIEW touch screen is used as the hardware base of the system, and the EV5000 of EVIEW is chosen as the communication program and system display between the system and the whole vehicle control unit of the hybrid drive system. Diagnostic interface programming software. According to the basic requirements of the system, the possible fault types of the parallel charging hybrid drive system are analyzed. In the control program of the whole vehicle control unit, a related subroutine is written to judge the possible faults, and a signal is generated after the judgment. This flag bit is the same as the address of the fault indicator lamp in the fault indication interface made in EVIEW, so that the fault signal is transmitted from the whole vehicle control unit to the touch screen. At the same time, the address of each parameter of the drive system in the PLC is the same as the address of each component in the display interface made in the touch screen. The real-time state and faults of the system parameters can be transmitted to the EVIEW touch screen, and the real-time monitoring and alarm of the system can be realized. The experiment shows that the diagnosis instrument can display the state of the parameters in the process of starting, accelerating, shifting and braking, and can prompt the alarm in the diagnosis interface in time when the system fails. The fault diagnosis of parallel charging hybrid drive system is basically realized, and the necessary experience is provided for further research and development.
【學位授予單位】：武漢理工大學
【學位級別】：碩士
【學位授予年份】：2011
【分類號】：TH165.3

【參考文獻】

相關期刊論文 前10條

1 陳豪,張為公;基于B/S的汽車駕駛機器人遠程故障診斷系統[J];北京汽車;2004年02期

2 王偉杰,趙學增,黃文濤;基于BP網絡的故障診斷正向推理方法[J];車用發動機;2001年04期

3 胡琳;汽車故障診斷專家系統診斷模型的研究[J];電子技術應用;1997年12期

4 杜曉慧,叢■,鄒振禮;汽車故障診斷技術簡論[J];黑龍江交通科技;2005年07期

5 王秉仁,姜小麗,張雷;基于模糊邏輯推理的汽車故障診斷的研究[J];機電工程;2005年10期

6 尹旭日,張從文,王教東;汽車故障診斷中基于粗糙集的CBR方法研究[J];交通與計算機;2005年01期

7 陳朝陽,張代勝,任佩紅;汽車故障診斷專家系統的現狀與發展趨勢[J];機械工程學報;2003年11期

8 張麗莉;儲江偉;強添剛;韓大明;鄒本存;;現代汽車故障診斷方法及其應用研究[J];機械研究與應用;2008年01期

9 曹建國,羅輯;基于神經網絡的發動機異響故障診斷方法[J];機械制造;2004年02期

10 尹旭日,周志華,陳世福;AFDES中基于Case推理方法的研究[J];計算機應用與軟件;2002年01期

，

本文編號：1376174