【摘要】：對汽車用AZ80合金進行擠壓鑄造,研究澆注溫度、擠壓壓力、模具預熱溫度和保壓時間對AZ80合金組織和力學性能的影響,并分析其作用機理。結果表明,AZ80合金的適宜擠壓鑄造工藝為:澆注溫度700℃、擠壓壓力90MPa、模具預熱溫度為250℃、保壓時間為25 s,在此工藝下的AZ80合金可以取得較好的強度和塑性結合;AZ80合金力學性能的提高,主要與擠壓工藝參數調控合金晶粒大小和顯微缺陷有關。
[Abstract]:The effects of pouring temperature, extrusion pressure, die preheating temperature and holding time on the microstructure and mechanical properties of AZ80 alloy for automobile were studied, and the mechanism of its action was analyzed. The results show that the suitable squeeze casting process of AZ80 alloy is as follows: pouring temperature 700 鈩，

本文編號：2201013