【摘要】：采用元胞自動機(CA)方法對高溫合金IN690管材擠壓變形過程中動態再結晶組織演變規律進行了數值模擬研究。確定了位錯密度模型、回復模型、形核模型、晶粒長大模型等。分析了擠壓變形過程中動態再結晶的過程,得到了變形過程中的晶粒形態、分布、取向和尺寸。結果表明,在相同擠壓比條件下,管壁外部的平均晶粒尺寸小于管壁中部;在管材的相同部位,隨著擠壓比的增大,平均晶粒尺寸減小。平均晶粒尺寸的數值模擬結果與實驗結果的相對誤差小于16.6%。
[Abstract]:The dynamic recrystallization microstructure evolution of superalloy IN690 tubes during extrusion deformation was studied numerically by cellular automata (CA) method. Dislocation density model, recovery model, nucleation model and grain growth model are determined. The dynamic recrystallization process during extrusion deformation was analyzed. The grain morphology, distribution, orientation and size were obtained. The results show that the average grain size outside the tube wall is smaller than that in the middle of the tube wall under the same extrusion ratio, and the average grain size decreases with the increase of extrusion ratio in the same part of the tube. The relative error between the numerical simulation and experimental results of average grain size is less than 16.6.
【作者單位】： 沈陽理工大學;沈陽工學院;
【基金】：國家自然科學基金(51575366)
【分類號】：TG132.3;TG376.9

【相似文獻】

相關期刊論文 前10條

1 姜科;孫圣潔;;動態再結晶臨界判據和機理的研究[J];有色金屬加工;2009年06期

2 臧爾壽;張厚君;;鈮對共析軌鋼動態再結晶的影響[J];物理測試;1990年01期

3 張鴻冰,張斌,柳建韜;鋼中動態再結晶力學測定及其數學模型[J];上海交通大學學報;2003年07期

4 李龍飛,楊王s，

本文編號：2160499