【摘要】：為了進一步提高電子束焊機工作的可靠性和穩定性,提高電子束加工質量,采用AC-DC-AC-DCAC-DC的拓撲電路和雙閉環控制策略設計制造了高壓加速電源、偏壓電源與燈絲加熱電源。將所研制高壓逆變電源與150 kV/30 kW電子槍、真空系統等組成了一套電子束焊接設備,分別測試了該電子束焊接設備輸出的高壓、最大束流、焊接工藝參數一致性、最大焊接深度。試驗結果表明,所研制的逆變電源高壓輸出達到150 kV,高壓輸出線性度較好;工藝參數一致性較好;最大束流達到200 mA;鈦合金焊接深度達到100 mm。這表明所研制的高壓逆變電子束焊接電源的焊接適用性良好。
[Abstract]:In order to further improve the reliability and stability of electron beam welding machine and improve the quality of electron beam processing, the high voltage accelerating power supply, bias voltage power supply and filament heating power source are designed and manufactured by using the topology circuit of AC-DC-AC-DCAC-DC and double closed loop control strategy. A set of electron beam welding equipment was made up of the developed high voltage inverter, 150 kV / 30 kW electron gun and vacuum system. The output high voltage, maximum beam current, welding process parameter consistency and maximum welding depth of the electron beam welding equipment were tested respectively. The experimental results show that the high voltage output of the inverter is 150 kV, the linearity of the high voltage output is good, the process parameters are consistent, the maximum beam current is 200 Ma, and the welding depth of titanium alloy is 100 mm. This indicates that the welding applicability of the developed high voltage inverter electron beam welding power source is good.
【作者單位】： 北京航空制造工程研究所高能束流加工技術重點實驗室;
【基金】：工信部基金資助項目
【分類號】：TG439.3

【相似文獻】

相關期刊論文 前1條

1 李向波;李世鍵;;退火次數對TA15鈦合金電子束焊接接頭力學性能的影響[J];熱加工工藝;2014年09期

，

本文編號：2137287