本文選題：中碳鋼 + 退火工藝��； 參考：《熱加工工藝》2017年20期

【摘要】：利用SEM、EBSD等分析技術研究了不同退火保溫時間對碳化物球化、鐵素體回復與再結晶以及實驗鋼力學性能的影響。結果表明:實驗鋼熱軋后空冷到650℃進行不同保溫時間的退火,當保溫時間達到30 min時,大多數鐵素體發生了再結晶,且鐵素體晶粒尺寸最為細小,約為7μm。熱軋實驗鋼的試樣屈服強度與抗拉強度均較高,分別為570 MPa和725 MPa,而伸長率為13%。當熱軋?jiān)嚇永鋮s到650℃進行30min的退火,其抗拉強度和屈服強度顯著降低,分別下降至460 MPa和635 MPa,而伸長率顯著增加,達到21%。
[Abstract]:The effects of different annealing time on carbide spheroidization, ferrite recovery and recrystallization and the mechanical properties of experimental steel were studied by means of SEMS-EBSD and other analytical techniques. The results show that the experimental steel is annealed at 650 鈩，

本文編號：2071851