本文選題：快速凝固 + 不混溶合金��； 參考：《Transactions of Nonferrous Metals Society of China》2017年01期

【摘要】：綜合采用熔融玻璃凈化、銅模噴鑄及單輥旋淬技術,對比研究不同過冷度、不同冷速作用下Cu-Co不混溶合金的快速凝固行為。通過對凝固發生時的熱流方式、形核及生長過程的分析,闡述合金非平衡組織由枝晶到分相結構的轉變及其相應尺寸的變化規律。隨過冷度增加,不混溶效應的增強導致柱狀枝晶向分相結構轉變。由于銅模噴鑄時發生多點形核,凝固組織呈現為等軸枝晶并隨冷速增加而不斷細化。當噴鑄試棒直徑為4 mm時,不混溶效應形成的液滴由于長大不充分最終形成細小粒狀分相組織。單輥旋淬薄帶由于冷速最高,凝固過程瞬間完成,可有效抑制液相分離的發生,有利于胞狀單相固溶體組織的形成。
[Abstract]:The rapid solidification behavior of Cu-Co immiscible alloys with different undercooling and different cooling rates was studied by means of melting glass purification, copper mold spray casting and single roll spinning. Based on the analysis of the heat flux, nucleation and growth process during solidification, the transformation from dendrite to phase separation structure of the alloy and the change of the corresponding size are described. With the increase of undercooling degree, the enhancement of immiscible effect leads to the transformation of columnar dendrite to phase separation structure. Due to the multi-point nucleation, the solidification structure presents equiaxed dendrite and refines with the increase of cooling rate. When the diameter of the spray cast rod is 4 mm, the droplets formed by the immiscible effect will form fine granular phase separation structure due to insufficient growth. Due to the highest cooling rate and the instantaneous completion of the solidification process, the single roll spinning strip can effectively inhibit the occurrence of liquid phase separation and is conducive to the formation of cellular single-phase solid solution structure.
【作者單位】： 西北工業大學凝固技術國家重點實驗室;南昌航空大學航空制造工程學院;
【基金】：Project(SKLSP201118)supported by the State Key Laboratory of Solidification Processing in Northwestern Polytechnical University,China Projects(51431008,51461032)supported by the National Natural Science Foundation of China Project(51125002)supported by the China National Natural Science Foundation for Distinguished Young Scholars Project(GJJ14504)supported by the Education Department of Jiangxi Province,China
【分類號】：TG146.11

【相似文獻】

相關期刊論文 前2條

1 郭景杰,崔紅保,蘇彥慶,畢維生,賈均,傅恒志;難混溶合金及其制備技術研究進展[J];特種鑄造及有色合金;2004年01期

2 ;[J];;年期

相關會議論文 前1條

1 張嘉鋒;周炳紅;康琦;胡良;劉秋生;;兩層不混溶液體中Bénard-Marangoni對流的實驗研究[A];流動顯示’2002第五屆全國流動顯示學術會議論文集[C];2002年

相關重要報紙文章 前1條

1 ;鈣在人體中的作用[N];市場報;2000年

相關碩士學位論文 前2條

1 謝偉偉;混溶驅動退化問題的數值方法研究[D];山東大學;2014年

2 王士付;Al基難混溶合金界面及凝固組織的研究[D];沈陽航空航天大學;2014年

，

本文編號：2047237