本文選題：激光技術 + 激光熔覆��； 參考：《激光與光電子學進展》2017年10期

【摘要】：在不同工藝參數下,在球墨鑄鐵QT450-10表面激光熔覆了鎳基合金,分析了熔覆層的顯微組織和物相組成,研究了熔覆前、后試樣的拉伸應力-應變曲線及試樣的斷口形貌。結果表明,當激光功率為1.6kW、激光掃描速率為400mm·min~(-1)、送粉速率為3.2r·min~(-1)時,熔覆結果較好,基體與熔覆層間形成了良好的冶金結合,無裂紋、氣孔;在25℃下,當熔覆層數為1時,熔覆層的顯微硬度達到265HV,約為基體硬度的1.5倍;熔覆后試樣的斷裂部位在基體處,熔覆鎳基合金的球墨鑄鐵的強度得到提高。
[Abstract]:The Ni-base alloy was laser cladding on the surface of nodular cast iron QT450-10 under different technological parameters. The microstructure and phase composition of the cladding layer were analyzed. The tensile stress-strain curves of the samples before and after cladding and the fracture morphology of the samples were studied. The results show that when the laser power is 1.6kW, the laser scanning rate is 400mm minmin-1, and the powder feeding rate is 3.2r / min ~ (-1), the cladding results are better, the metallurgical bonding between the matrix and the cladding layer is good, there is no crack and porosity, and at 25 鈩，

本文編號：2019697