發布時間：2018-05-27 07:41

  本文選題：AISI鋼 + 熱膨脹　； 參考：《鋼鐵》2017年03期

【摘要】：采用熱膨脹法測定了AISI4340鋼的固態相變點,觀察了組織和硬度,研究了不同熱處理狀態對臨界點和奧氏體連續冷卻轉變曲線(CCT曲線)的影響。結果表明,試驗鋼具有較好的淬透性,冷速為0.03℃/s時得到單一貝氏體組織,冷速為0.03~0.78℃/s之間得到馬氏體和貝氏體混合組織,冷速大于0.78℃/s時相變組織都為馬氏體。不同熱處理狀態對ATSI4340鋼的A_(c1)、A_(c3)有影響,而CCT曲線沒有明顯差別。彌散分布、介穩定的組織具有較低的A_(c1),原始組織對A_(c1)的影響比A_(c3)大。
[Abstract]:The solid phase transformation point of AISI4340 steel was measured by thermal expansion method. The microstructure and hardness were observed. The effects of different heat treatment conditions on the critical point and the continuous cooling transformation curve of austenite were studied. The results show that the test steel has good hardenability, and the single bainite structure is obtained at the cooling rate of 0.03 鈩，

本文編號：1941111