本文選題：螺旋錐齒輪 + 盤狀銑刀　； 參考：《機床與液壓》2017年06期

【摘要】：針對螺旋錐齒輪在數控加工中心上加工效率低的問題,提出利用盤狀銑刀對螺旋錐齒輪進行端銑的加工方法。由螺旋錐齒輪齒面及刀具的幾何特征,調整銑刀與被加工齒面的相對位置,使齒面與刀具包絡面的法截面相對法曲率最小,增大切削帶寬,同時控制刀軸矢量調整切削深度避免加工干涉。最后將規劃的加工刀位轉化到數控機床軸上,利用VERICUT進行加工仿真驗證該方法的可行性與正確性。
[Abstract]:Aiming at the problem of low machining efficiency of spiral bevel gear in NC machining center, a method of end milling of spiral bevel gear with disc milling cutter is put forward. According to the geometric characteristics of the tooth surface and cutter of spiral bevel gear, the relative position of the milling cutter and the machined tooth surface is adjusted to minimize the normal cross-section relative normal curvature between the tooth surface and the cutter envelope surface, and to increase the cutting bandwidth. At the same time, control the cutter axis vector to adjust the cutting depth to avoid machining interference. Finally, the tool position is transformed to the axis of NC machine tool, and the feasibility and correctness of the method are verified by VERICUT machining simulation.
【作者單位】： 重慶理工大學機械工程學院;
【基金】：supported by National Natural Science Foundation of China (51175531) open research fund of the Key Laboratory of Jiangsu Province Industrial equipment Digital Manufacturing and Control Technology (DM2015002) Chongqing University of Technology postgraduate innovation project (YCX2015209)
【分類號】：TG611

【參考文獻】

相關期刊論文 前4條

1 王斌;鄧效忠;賈新杰;李更更;;盤刀加工等基圓錐齒輪的刀具位姿及運動軌跡計算[J];中國機械工程;2013年19期

2 李鋒;居海軍;;對數螺旋錐齒輪加工中刀具走刀軌跡方程的分析與確定[J];現代制造工程;2009年08期

3 張威;王太勇;羅s，

本文編號：1939748