本文選題：粉末高溫合金 + 熱變形　； 參考：《金屬學報》2017年11期

【摘要】：采用單軸熱壓縮實驗,研究了熱等靜壓態鎳基粉末高溫合金FGH98的熱加工變形行為。觀察了形變過程中的合金組織演變,分析了顯微組織不穩定性對熱塑性的影響。熱壓縮實驗在等溫、恒應變速率下進行,真應變分別為0.2、0.4和0.6,溫度分別為1060、1105、1138和1165℃,應變速率分別為0.01、0.1、1和10 s-1。結果表明,隨著真應變的增加,合金的真應力-真應變曲線上出現硬化-軟化-穩態流變階段。在低于g′相完全溶解溫度、合金處在穩態流變或高應變條件下時,發生應變誘發動態再結晶并形成特殊形態的g+g′顯微雙相晶粒組織。晶粒尺寸細小,達到1.2~6.8μm,合金顯示良好的熱塑性。分析了變形過程中晶粒尺寸和流變應力的變化和g+g′顯微雙相晶粒組織形成機理,并對熱加工過程中顯微組織調控的可能性進行討論。
[Abstract]:The hot working deformation behavior of hot isostatic nickel base superalloy (FGH98) was studied by uniaxial compression test. The microstructure evolution during deformation was observed and the effect of microstructure instability on thermoplasticity was analyzed. The thermal compression experiments were carried out at isothermal and constant strain rates. The true strain was 0.20.4,0.6, the temperature was 1060,1105U 1138 and 1165 鈩，

本文編號：1861802