本文選題：軋機軸承 + 推力軸承　； 參考：《軸承》2017年12期

【摘要】：以某1 580 mm熱軋精軋工作輥推力軸承為例,通過分析PDA曲線初步推斷推力軸承的失效是由異常軸向力造成。通過對軸向力來源進行分析,得出軋輥交叉是造成推力軸承失效的主要原因;進一步分析軋機平衡塊和軸承座結構對軸承偏載的影響,提出軋機彎竄系統和軸承座的改造方案,并提出在推力軸承上增加隔圈以提高推力軸承的承載能力,防止?jié)L動體被擠壓變形。經驗證,改進方案滿足工程應用需求。
[Abstract]:Taking a 1 580mm hot rolling work roll thrust bearing as an example, the failure of the thrust bearing is preliminarily inferred by analyzing the PDA curve because of the abnormal axial force. Through the analysis of axial force source, it is concluded that roll crossing is the main reason for the failure of thrust bearing, and the influence of balance block and bearing seat structure on bearing bias load is further analyzed, and the transformation scheme of rolling mill bending and channeling system and bearing seat is put forward. The bearing capacity of thrust bearing is improved by adding spacer to the thrust bearing to prevent the rolling body from being extruded and deformed. It is proved that the improved scheme can meet the requirement of engineering application.
【作者單位】： 首鋼京唐公司;
【分類號】：TG333.17
，

本文編號：1841315