發布時間：2018-04-23 14:20

  本文選題：吸收式熱泵 + L不銹鋼��； 參考：《熱加工工藝》2017年22期

【摘要】：在吸收式熱泵工況條件下,采用二次回歸正交設計研究了熱泵用管材316L不銹鋼在熱網水中的點蝕電位Eb關于溫度、Cl-濃度和p H值的關系,建立了三元二次回歸模型。結果表明,各因素對316L不銹鋼點蝕電位影響的顯著程度為p H值溫度Cl-濃度,且溫度與p H值、Cl-濃度與p H值的交互作用較為明顯。溫度與Cl-濃度對點蝕電位影響負相關,而p H值則正相關。隨溫度的升高,其顯著性在減弱,當高于75℃時,溫度對點蝕電位影響則正相關但作用微弱。p H值的顯著性明顯且隨p H值增大而增大。熱網水中Cl-濃度較小,其對316L不銹鋼的腐蝕無顯著性影響。在熱泵運行過程中應注意熱網水p H值與溫度的變化,把p H值控制在10.5及其以上為宜。
[Abstract]:Under the condition of absorption heat pump, the relationship between the pitting potential of 316L stainless steel for heat pump in hot net water and pH value was studied by quadratic regression orthogonal design, and a ternary quadratic regression model was established. The results show that the significant effect of various factors on pitting potential of 316L stainless steel is the pH value temperature Cl- concentration, and the interaction between temperature and pH value Cl- concentration and pH value is more obvious. The effect of temperature and Cl- concentration on pitting potential is negatively correlated, while pH is positively correlated. When the temperature is higher than 75 鈩，

本文編號：1792325