本文選題：高強度鋼方管 + 冷成形��； 參考：《上海交通大學學報》2017年04期

【摘要】：針對直接冷彎成形工藝制備的高強度鋼方管出現彎角力學性能下降、冷作硬化效應明顯和殘余應力集中等問題,提出了在線局部感應回火工藝.該工藝有效解決了冷成形高強度鋼方管角部缺陷問題,并發現不同感應回火溫度對彎角力學性能有較大的影響.結果表明:當回火溫度在650℃時,方管彎角處強度和延伸率與原材料性能接近,在酸洗壓扁實驗中的壓下量超過方管對角線1/2仍沒有裂紋出現,殘余應力大小和分布也得到一定程度的改善;當回火溫度為700℃時,高強度鋼方管彎角強度開始降低,熱影響區變大,殘余應力分布異常.
[Abstract]:Aiming at the problems of low angle mechanical properties, obvious hardening effect and residual stress concentration in high strength steel square tubes prepared by direct cold forming, an on-line local induction tempering process is proposed. This process effectively solves the problem of corner defect of high strength steel tube in cold forming, and it is found that different induction tempering temperature has great influence on the mechanical properties of bending angle. The results show that when the tempering temperature is at 650 鈩，

本文編號：1790635