本文選題：熱處理　切入點：AZ鎂合金　出處：《東北大學學報(自然科學版)》2017年11期

【摘要】：通過常溫下的銷盤式干滑動摩擦磨損試驗,研究固溶及不同時間的時效處理對鑄態AZ61鎂合金摩擦磨損性能的影響.試驗載荷為100 N,滑動速度為0.78 m/s,滑動距離為1 km.結果表明:固溶處理使鑄態合金中的粗大β-Mg17Al12相溶解,導致合金的硬度降低,摩擦系數和磨損率升高;在170℃下對AZ61合金進行不同時間(0~80 h)的時效處理使尺寸細小的β相在晶內和晶界處析出,提高了合金的耐磨性,其中時效20 h后合金的摩擦系數和磨損率最低.AZ61合金在摩擦磨損的過程中共存在三種磨損機制:磨粒磨損、氧化磨損及剝層磨損.
[Abstract]:Through the dry sliding friction and wear test at room temperature, The effects of solid solution and aging treatment at different time on the friction and wear properties of as-cast AZ61 magnesium alloy were studied. The test load is 100N, the sliding speed is 0.78 m / s, and the sliding distance is 1 km 路s. The results show that the coarse 尾 -Mg17Al12 phase in the as-cast alloy can be dissolved by solid solution treatment. The hardness of the alloy decreased, the friction coefficient and wear rate increased, and the aging treatment of AZ61 alloy at 170 鈩，

本文編號：1669004