本文選題：硬質合金刀具　切入點：不銹鋼　出處：《沈陽工業大學學報》2017年03期

【摘要】：為了研究硬質合金刀具切削不銹鋼材料時刀-屑粘焊的臨界條件,并獲得切削參數對切削溫度及粘焊累積的影響規律,采用Design-Expert軟件響應曲面法進行分析.通過三因素三水平試驗建立了在硬質合金刀具切削1Cr18Ni9Ti不銹鋼過程中切削溫度的預測模型,并對相應的回歸模型進行了分析,證明了預測模型以及對應因素的顯著性.結果表明:該預測模型較為準確,具有較好的可靠性和實用性;刀-屑粘焊的溫度區范圍一般不超過800℃;刀具前刀面粘焊微觀形貌呈現一定程度的顆粒扎堆狀態;切削速度和進給量的交互作用對切削溫度的影響最為顯著.
[Abstract]:In order to study the critical condition of cutter chip bonding welding in cutting stainless steel material with cemented carbide tool, the influence of cutting parameters on cutting temperature and bonding accumulation is obtained. By using the response surface method of Design-Expert software, the prediction model of cutting temperature in the process of cutting 1Cr18Ni9Ti stainless steel with cemented carbide tool was established by three factors and three levels test, and the corresponding regression model was analyzed. The prediction model and the significance of corresponding factors are proved. The results show that the prediction model is more accurate, has better reliability and practicability, and the temperature range of knife chip bonding welding is generally less than 800 鈩，

本文編號：1659035