本文選題：模具預熱溫度　切入點：始鍛溫度　出處：《熱加工工藝》2017年23期 　論文類型：期刊論文

【摘要】：采用不同的模具預熱溫度、始鍛溫度和終鍛溫度對Cu-Zn基汽車同步器齒環進行了鍛造,并進行了磨損性能和沖擊性能的測試與分析。結果表明:在試驗條件下,隨模具預熱溫度從200℃升高至300℃、始鍛溫度從720℃升高至800℃或終鍛溫度從590℃升高至710℃,齒環的磨損性能和沖擊性能均先提高后下降。Cu-Zn基汽車同步器齒環的最佳工藝參數為:模具預熱溫度275℃、始鍛溫度780℃、終鍛溫度690℃。
[Abstract]:Different preheating temperature, starting forging temperature and final forging temperature were used to forge the gear ring of Cu-Zn based automobile synchronizer, and the wear and impact properties were tested and analyzed. The results show that under the test conditions, the wear and impact properties of the ring are tested and analyzed. With the increase of preheating temperature from 200 鈩，

本文編號：1620995