本文選題：鑄輾復合成形　切入點：QB鋼法蘭　出處：《金屬熱處理》2017年02期 　論文類型：期刊論文

【摘要】：鑄輾復合成形的法蘭內部存在較大的殘余應力,而且晶粒尺寸分布不均,從而造成部分區域的力學性能不能滿足實際要求,給應用帶來安全隱患。本文以鑄輾復合成形的Q235B鋼法蘭為研究對象,利用光學顯微鏡、掃描電鏡和力學性能試驗等方法,研究熱處理工藝參數對Q235B鋼法蘭微觀組織及力學性能的影響,探討最佳的熱處理工藝。試驗結果表明:鑄輾成形后的Q235B鋼法蘭經900℃淬火保溫1 h,在10%Na Cl水溶液中冷卻后600℃回火保溫2 h,力學性能達到實際使用要求。
[Abstract]:The internal residual stress in the flange formed by casting and rolling is large and the distribution of grain size is uneven, which results in the mechanical properties of some areas can not meet the actual requirements. This paper takes the Q235B steel flange formed by casting and rolling as the research object, using optical microscope, scanning electron microscope and mechanical property test, etc. The effect of heat treatment process parameters on microstructure and mechanical properties of Q235B steel flange was studied. The experimental results show that the Q235B steel flange is quenched at 900 鈩，

本文編號：1620818