本文選題：電阻點焊　切入點：焊接參數　出處：《焊接學報》2017年08期 　論文類型：期刊論文

【摘要】：采用不同焊接工藝對TRIP980鋼板進行點焊試驗,研究了焊接電流、焊前預熱及焊后熱處理工藝對點焊性能的影響.結果表明,隨著焊接電流的增大,焊點的熔核直徑和拉剪力均增大,但當電流過大而發生飛濺時,焊點的熔核直徑和拉剪力開始減小.焊前預熱工藝可提高點焊飛濺電流,進而可以獲得更大的熔核直徑及拉剪力.在對焊點進行焊后熱處理的情況下,當焊接電流與焊后熱處理電流之間的冷卻時間超過900 ms時,可顯著改善熔核組織,降低熔核硬度,提高焊點拉剪力.
[Abstract]:The effect of welding current, preheating before welding and heat treatment after welding on spot welding properties of TRIP980 steel plate was studied by using different welding processes. The results show that the welding current increases with the increase of welding current. The nugget diameter and tensile shear force of solder joint increase, but when the current is too large and spatter occurs, the nugget diameter and pull shear force of solder joint begin to decrease. Furthermore, larger nugget diameter and tensile shear force can be obtained. When the cooling time between welding current and post-weld heat treatment current exceeds 900 Ms, the microstructure and hardness of the nugget can be significantly improved. Increase the tensile shear force of solder joint.
【作者單位】： 中國科學院金屬研究所沈陽材料科學國家聯合實驗室;
【基金】：沈陽材料科學國家(聯合)實驗室青年人才資助項目(2017FP32)
【分類號】：TG161;TG453.9
，

本文編號：1565213