本文關鍵詞： 塑料模具鋼 厚板 預硬化工藝　出處：《金屬熱處理》2017年01期 　論文類型：期刊論文

【摘要】：在開發(fā)過程中,通過熱模擬試驗、金相觀察確定了塑料模具鋼4Cr2Mn2Mo的成分范圍和組織構成;通過實驗室和大生產試驗選取了最佳預硬化工藝制度。研究表明,采用控軋控冷+回火工藝,將終軋溫度控制在905℃以上,軋后空冷到300~350℃,緩冷至室溫,在560℃下回火的熱處理工藝,成功開發(fā)出厚度≥150 mm,組織為回火馬氏體+貝氏體,硬度均勻且滿足鋼板預硬態(tài)300~350 HBW企業(yè)標準要求的模具鋼厚板。
[Abstract]:During the development process, the composition range and microstructure of plastic mould steel 4Cr2Mn2Mo were determined by metallographic observation through thermal simulation test. The optimum pre-hardening process was selected through laboratory and large scale production tests. The results showed that the final rolling temperature was controlled above 905 鈩，

本文編號：1452555