【摘要】：通過在水基AM-MBAM-YSZ漿料中加入水溶性高分子PEG,并將可反應單體與引發劑分離,制備了固相含量為52vol%,室溫下可穩定儲存數天、混合后固化可控的雙組份打印漿料。漿料粘度為11.2 Pa·s(剪切速率100s-1),屈服應力為510.7 Pa,漿料打印的線條尺寸均勻、邊緣平整,坯體表面無剝離,燒結后顯微結構均勻致密。打印線條燒結后的相對密度為99.3%,圓柱試樣燒結后的相對密度為95.6%。
[Abstract]:The water-soluble high-molecular PEG was added to the water-based AM-MBAM-YSZ slurry, and the reactive monomer was separated from the initiator to prepare the two-component printing slurry with the solid phase content of 52 vol% and stable storage for several days at room temperature. The viscosity of the slurry is 11.2 Pa.s (shear rate 100s-1), the yield stress is 510.7Pa, the size of the line printed by the slurry is uniform, the edge is flat, the surface of the blank is not stripped, and the microstructure is even and compact after sintering. The relative density of the printed line after sintering is 99.3%, and the relative density after the sintering of the cylindrical sample is 95.6%.
【作者單位】： 華中科技大學材料科學與工程學院材料成型與模具技術國家重點實驗室;
【基金】：國家高技術研究發展計劃(863計劃)(2006AA032443)
【分類號】：TQ174.1

【相似文獻】

相關期刊論文 前1條

1 張先如,孫嘉,徐政;PEG在微波誘導下對高嶺石插層及剝片的研究[J];無機化學學報;2005年09期

相關碩士學位論文 前1條

1 金花;Fe_3O_4納米顆粒的表面接枝修飾及其對PEG結晶行為的影響[D];華中科技大學;2014年

，

本文編號：2451536