發布時間：2018-04-22 08:07

  本文選題：鋁錫復合材料 + 機械合金化　； 參考：《功能材料》2017年06期

【摘要】：研究了鋁錫復合材料與純水反應過程中的產氫特性。所提及的鋁錫復合材料全部采用機械球磨的方法制備而成。不同成分復合材料的相組成和表面形貌分別用X射線衍射儀(XRD)和掃描電子顯微鏡(SEM)進行表征。研究結果表明,增加金屬Sn的含量、提高起始反應溫度、添加助磨劑NaCl和添加低熔點金屬(Bi、In等),可以提高鋁錫復合材料的活性,增加產氫量以及產氫速率。通過調整添加劑種類和添加量得到成分比例(質量分?jǐn)?shù))為Al-6%Sn-2%Bi-2%In的合金在25℃的水浴中水解30min的產氫量為785.6mL/g,最大產氫速率可以達到175mL/(min·g)。
[Abstract]:The hydrogen production characteristics of Al-tin composites during reaction with pure water were studied. The aluminum-tin composites mentioned above were all prepared by mechanical ball milling. The phase composition and surface morphology of the composites were characterized by X-ray diffractometer (XRD) and scanning electron microscopy (SEM). The results show that the activity, hydrogen production and hydrogen production rate of Al-Sn composites can be improved by increasing the content of Sn, increasing the initial reaction temperature, adding grinding aids NaCl and adding low melting point metal Bi-In. By adjusting the kinds of additives and the amount of additives, the hydrogen production of 30min hydrolyzed in 25 鈩，

本文編號：1786311