本文關鍵詞： 二次炭粒 純碳反應燒結 SiC 顯微結構　出處：《中國陶瓷》2016年07期 　論文類型：期刊論文

【摘要】：用二次炭粒制備了純碳反應燒結碳化硅(PCRBSC),研究了二次炭粒的密度、粒徑及顆粒粘結狀態對燒結體顯微結構的影響。結果表明:當二次炭粒的密度為0.844 g/cm~3、粒徑小于37μm時,燒結體中幾乎沒有fC的存在,但二次炭粒密度過低會導致fSi含量增加;加入粘結劑可以改善二次炭粒高溫時的粘結強度,防止燒結開裂而出現硅線。
[Abstract]:Pure carbon reaction sintering silicon carbide (PCRBSCS) was prepared from secondary carbon particles. The effects of the density, particle size and particle bonding state of secondary carbon particles on the microstructure of the sintered particles were studied. The results showed that when the density of secondary carbon particles was 0.844 g / cm ~ (-3), the particle size was less than 37 渭 m. There is almost no fC in the sintered body, but the low density of secondary carbon particle will lead to the increase of fSi content, and the addition of binder can improve the bond strength of secondary carbon particle at high temperature and prevent the silicon wire from cracking.
【作者單位】： 清遠職業技術學院機電工程學院;武漢理工大學硅酸鹽材料與工程教育部重點實驗室;
【分類號】：TQ174.1

【相似文獻】

相關期刊論文 前2條

1 曾桃芳,傅維標;關于碳/炭粒表面氧化反應生成物CO/CO_2比值的研究[J];工程熱物理學報;1993年02期

2 ;[J];;年期

，

本文編號：1520247