本文關鍵詞： 工藝條件 模具石膏 凝結時間 強度 吸水率　出處：《硅酸鹽通報》2017年04期 　論文類型：期刊論文

【摘要】：通過對比試驗研究了水膏比、攪拌速度、攪拌時間、拌合水溫度對模具石膏凝結時間、強度、吸水率性能的影響,并結合SEM、XRD技術探索其影響機理。結果表明:模具石膏成型時合適的工藝條件為水膏比65%~70%,攪拌速度400~500 r/min,攪拌時間2~3 min,拌合水溫度25~30℃;水膏比、攪拌速度、攪拌時間、拌合水溫的變化直接影響了二水石膏的結晶化程度和晶體形態。
[Abstract]:The effects of water / paste ratio, stirring speed, stirring time and mixing water temperature on the setting time, strength and water absorption of gypsum were studied by contrast test, and combined with SEM. The XRD technique was used to explore its influence mechanism. The results showed that the suitable technological conditions were as follows: the ratio of water to paste was 6570 and the stirring speed was 400 ~ 500rmin. The mixing time is 2 ~ 3 min, the mixing water temperature is 2530 鈩，

本文編號：1489940