發布時間：2018-06-29 10:00

  本文選題：DAC + 數模轉換器　； 參考：《微電子學與計算機》2017年11期

【摘要】：基于SMIC 28nm CMOS工藝,實現了一款增益可調的三通道的300MS/s 10bit的數模轉換器.此數模轉化器可以通過5位的控制字實現0~-5.75dB的增益調節,適應更多的應用環境.數模轉換器采用分段式結構,其中高六位采用溫度計碼,低四位采用二進制碼.在電流源單元開關部分采用限幅電路,提高無雜散動態范圍.帶隙基準單元采用低電壓輸出結構,滿足電壓電流轉換單元中的柵壓要求.在1.8V模擬電源電壓,1.05V數字電壓下,采樣時鐘在300 MHz的時候,無雜散動態范圍(SFDR)為64dB,微分非線性小于(DNL)±0.3LSB;積分非線性小于(INL)±0.4LSB.
[Abstract]:Based on SMIC 28nm CMOS technology, a three-channel digital-to-analog converter with three channels, 300MS / s 10bit, is implemented. This digital-analog converter can realize gain adjustment of 0 ~ 5.75 dB through 5-bit control word, which is suitable for more application environment. The digital-to-analog converter adopts a segmented structure, in which the thermometer code is used for the high six bits and the binary code is used for the lower four bits. The limiting circuit is used in the switch part of the current source unit to improve the non-spurious dynamic range. The bandgap reference unit adopts a low voltage output structure to meet the gate voltage requirements in the voltage-current conversion unit. At 1.8V analog power supply voltage of 1.05V, the sampling clock at 300MHz has a non-spurious dynamic range (SFDR) of 64dB, differential nonlinearity less than (DNL) 鹵0.3LSBand integral nonlinearity less than (INL) 鹵0.4LSB.
【作者單位】： 中國科學院微電子研究所;中國科學院大學;
【基金】：國家科技重大專項資助項目(Y4GZ242001)
【分類號】：TN792

【相似文獻】

相關期刊論文 前10條

1 ;Cirrus Logic CS434x系列數模轉換器及應用[J];今日電子;2004年03期

2 程君俠;鮑慧君;洪遠豐;王煜;;4E601單片六位數模轉換器[J];電子技術;1980年03期

3 越川常治;王龍飛;;數模轉換器的構成概要和最近技術動向[J];國外艦船技術.雷達與對抗類;1981年10期

4 安龍虎;一個數模轉換器[J];電測與儀表;1983年07期

5 劉清`，

本文編號：2081751