共光路三自由度激光測量系統
本文選題:共光路 + 激光。 參考:《光電工程》2017年08期
【摘要】:基于邁克爾遜干涉原理和激光自準直原理,采用共光路布局,研制了能對運動工作臺同時進行一維位移和二維角度測量的三自由度激光測量系統。在位移測量中,采用光程差放大技術,并結合偏振干涉技術和信號差分處理,得到高質量的位移輸出信號和高分辨力的位移測量結果。在角度測量中,運動工作臺的偏擺和俯仰運動會引起固定在工作臺上的反射鏡位置變化。入射光被反射鏡反射,并被四象限探測器探測,根據四象限探測器上的光斑位置變化,獲得偏擺角和俯仰角的變化值。對研制的系統進行穩定性和分辨力測試,同時與英國雷尼紹XL-80激光干涉儀進行比對實驗。實驗結果表明:測量系統的位移分辨力為0.8 nm,角度分辨力為0.2″;在50 mm的測量范圍內,與雷尼紹XL-80激光干涉儀測量值相比,系統的位移最大偏差小于100 nm,偏擺角最大偏差為0.5″,俯仰角最大偏差為0.4″。
[Abstract]:Based on Michelson interference principle and laser self-collimation principle, a three-degree-of-freedom laser measurement system is developed, which can measure the one-dimensional displacement and two-dimensional angle of the moving table simultaneously. In the displacement measurement, high quality displacement output signal and high resolution displacement measurement result are obtained by using optical path difference amplification technique, polarization interferometry and signal differential processing. In angle measurement, the deflection and pitching movement of the moving table cause the change of the mirror position fixed on the table. The incident light is reflected by the reflector and detected by the four-quadrant detector. According to the change of the spot position on the four-quadrant detector, the variation values of the deflection angle and the pitch angle are obtained. The stability and resolution of the system were tested and compared with Renishaw XL-80 laser interferometer. The experimental results show that the displacement resolution of the system is 0.8 nm and the angular resolution is 0.2 ". The maximum deviation of displacement is less than 100 nm, the maximum deviation of deflection angle is 0.5 ", and the maximum deviation of pitch angle is 0.4".
【作者單位】: 合肥工業大學儀器科學與光電工程學院;合肥工業大學電子科學與應用物理學院;
【基金】:國家自然科學基金資助項目(51475131)
【分類號】:TH744.5
【相似文獻】
相關期刊論文 前10條
1 毅;組裝式激光測量系統[J];工具技術;1973年06期
2 殷純永,丁慎訓,張國貞;自動補償雙頻激光測量系統[J];清華大學學報(自然科學版);1979年02期
3 王旭芳;雙頻激光測量系統的調整[J];鐵道機車車輛工人;1998年06期
4 G.E.Sommargren;張孺慕;;精密測量中用的新激光測量系統[J];國外計量;1989年04期
5 李長勝,郝文思,王學讓;機械加工幾何精度的激光測量系統[J];河南機電高等?茖W(xué)校學報;2002年02期
6 苑蘇萌;;智能激光測量系統設計[J];工業計量;2012年S1期
7 高媛,郭立莎;雙頻激光測量系統測角誤差分析[J];計量技術;2002年09期
8 趙秉慶,,鄭偉昕;激光測量系統探查及校準[J];計量與測試技術;1995年05期
9 楊星,袁哲俊,董申;雙頻激光測量系統空氣參數實時補償[J];制造技術與機床;1997年03期
10 ;JJX-1型雙頻激光測量系統通過技術鑒定[J];計量技術;1986年05期
相關重要報紙文章 前1條
1 李明;磚坯厚度激光測量系統[N];中國鄉鎮企業報;2003年
相關碩士學位論文 前4條
1 蔡學超;基于LabVIEW的單頻激光測量系統誤差補償技術的研究[D];合肥工業大學;2016年
2 武萬多;二維多自由度激光測量系統研制[D];合肥工業大學;2016年
3 李強;四軸三維激光測量系統及自動拼合技術研究[D];華中科技大學;2007年
4 聶恒衛;基于激光測量系統的數據測量和數據處理技術研究[D];江南大學;2006年
本文編號:2067594
本文鏈接:http://sikaile.net/kejilunwen/dianzigongchenglunwen/2067594.html