本文選題：環形雙模諧振器 + 全集總參數　； 參考：《南京郵電大學》2017年碩士論文

【摘要】：濾波器件的小型化設計技術一直是高密度集成無線微波通信系統的關鍵,也是小型化微波系統設計的重點和難點�；诃h(huán)形雙模諧振器的濾波器能夠在提高濾波器選擇性能的同時有效減小濾波器的尺寸,從而被廣泛應用于濾波器件的設計。同時,隨著集成無源器件(Integrated Passive Device,IPD)技術的發展使得濾波器件的進一步小型化成為了可能。因此,為了滿足目前各類先進微波系統對器件尺寸所提出的更高要求,本文對基于IPD技術的環形雙模諧振器及其相關濾波器件的小型化設計技術進行了研究,主要工作內容及創新點如下:1.提出了一種全集總參數元件的雙模諧振器拓撲結構,定量給出了集總參數結構的環形雙模帶通濾波器電路中各集總參數元件初值計算方法,并采用薄膜IPD技術,設計了一款基于集總參數的超小型化環形雙模帶通濾波器,其中心頻率為1GHz,物理面積尺寸為4.0mm×2.6mm (0.0133λ0×0.0087λ0) 。2.基于所提出的全集總元件雙模諧振器的拓撲結構,采用IPD技術,設計了一種基于集總參數雙模諧振器的小型化C波段雙工器,該雙工器采用一組并聯短路微帶線來構成其阻抗匹配結構,整體面積尺寸為2.488mm×2.668mm。3.對全集總參數的雙模帶通濾波器中電容元件對濾波器性能的影響進行深入研究,給出了濾波器中心頻率以及帶寬隨電容元件的變化規律,在此基礎上,設計一款基于集總參數雙模諧振器的小型化UHF頻段的三維混合集成可調帶通濾波器,該濾波器的核心尺寸為14.42mm×9.306mm×2.394mm 。
[Abstract]:The miniaturization design technology of filter parts is the key of high density integrated wireless microwave communication system, and it is also the key and difficult point in the design of miniaturized microwave system. The filter based on ring double mode resonator can improve the performance of filter selection and reduce the size of filter, so it is widely used in the design of filter parts. At the same time, with the development of integrated passive device integrated Passive device, it is possible to further miniaturize the filter. Therefore, in order to meet the higher requirements of various advanced microwave systems for device size, the miniaturization design technology of ring dual-mode resonator and its related filter parts based on IPD technology is studied in this paper. The main contents and innovations are as follows: 1. In this paper, a topology structure of dual-mode resonator with lumped parameters is proposed. The method of calculating the initial values of each lumped parameter element in the loop dual-mode band-pass filter circuit with lumped parameter structure is presented quantitatively, and the thin film IPD technique is used. A super-miniaturized ring dual-mode band-pass filter based on lumped parameters is designed. Its center frequency is 1GHz and the physical area size is 4.0mm 脳 2.6mm 0.0133 位 0 脳 0.0087 位 0) .2. Based on the proposed topology of the full lumped element dual-mode resonator, a miniaturized C-band duplex based on lumped parameter dual-mode resonator is designed by using IPD technology. A series of parallel short circuit microstrip lines are used to construct the impedance matching structure. The overall area size of the duplex is 2.488mm 脳 2.668mm. 3. The effect of capacitive elements on the performance of dual-mode band-pass filters with lumped parameters is studied, and the variation of the central frequency and bandwidth of the filters with the capacitive components is given. A three-dimensional hybrid tunable band-pass filter based on lumped parameter dual-mode resonator is designed for miniaturized UHF band. The core size of the filter is 14.42mm 脳 9.306mm 脳 2.394mm.
【學位授予單位】：南京郵電大學
【學位級別】：碩士
【學位授予年份】：2017
【分類號】：TN713

【參考文獻】

相關期刊論文 前1條

1 李應選;用于集成無源器件的工藝技術[J];電子產品世界;2001年01期

相關博士學位論文 前2條

1 金秀華;小型環形結構微波濾波器研究[D];南京郵電大學;2014年

2 錢可偉;基于LTCC技術的無源器件研究[D];電子科技大學;2012年

相關碩士學位論文 前2條

1 李旭東;LTCC集總參數雙工器設計與建模[D];西安電子科技大學;2011年

2 張大龍;基于LTCC技術的微波傳輸線建模與設計[D];西安電子科技大學;2007年

，

本文編號：1930830