本文選題：激光技術 + 激光環切　； 參考：《激光與光電子學進展》2017年01期

【摘要】：采用控制變量法對GH4037高溫合金進行了激光環切打孔實驗,得到了脈沖能量、離焦量、環切速度、環切圈數對小孔錐度和上下孔徑的影響規律。結果表明,脈沖能量和離焦量對小孔孔徑和錐度的影響較大,而環切速度和環切圈數主要影響小孔的形貌。離焦量的絕對值越大,熱影響區、上孔徑和錐度也越大;增加環切圈數及適當?shù)沫h(huán)切速度(3~6mm/min)有助于提升小孔的質量,使孔口堆積物減少,且孔的圓度較好。
[Abstract]:The effect of pulse energy, defocus, circumferential tangent velocity and annulus number on the taper and the upper and lower aperture of GH4037 superalloy were obtained by using the control variable method. The results show that the pulse energy and defocus have great influence on the pore diameter and taper, while the ring cutting speed and the annular circle number mainly affect the morphology of the pore. The larger the absolute value of defocus, the larger the heat affected zone, the larger the aperture and the taper, and the higher the circumferential circle number and the proper annular cutting speed are, the higher the quality of the pore is, the less the accumulation of the hole is, and the better the roundness of the hole is.
【作者單位】： 江蘇大學機械工程學院;無錫職業技術學院;
【基金】：國家973計劃(2011CB013004) 江蘇省高校自然科學研究項目(11KJA460003,15KJD460002) 江蘇省科技支撐計劃(BE2015037) 江蘇省高�！扒嗨{(lán)工程”資助 江蘇省“六大人才高峰”項目(2013-ZBZZ-025)
【分類號】：TN249

【相似文獻】

相關會議論文 前1條

1 秦澎湃;黃斌;蔡Y鈰，

本文編號：1905652