本文選題：有機光電探測器 + 紅光��； 參考：《發光學報》2017年12期

【摘要】：采用旋涂工藝與蒸鍍工藝結合的方法制備了PBDT-TT-F∶PCBM體異質結紅光探測器,研究了活性層的混合比例和厚度、退火溫度等因素對器件光電特性的影響。實驗結果表明:活性層PBDT-TT-F∶PCBM的混合質量比為1∶1.5、厚度為150 nm、退火溫度為100℃、時間為15 min時制備的器件性能最佳,在波長為650nm、功率為6.6 m W/cm~2的光照下,探測器光電流密度可達到0.85 m A/cm~2,光響應度達到128 m A/W。
[Abstract]:The PBDT-TT-F:PCBM heterojunction red photodetectors were fabricated by the combination of spin-coating and evaporation. The effects of the mixing ratio and thickness of the active layer and annealing temperature on the photoelectric properties of the device were studied. The experimental results show that when the mixing mass ratio of active layer PBDT-TT-F:PCBM is 1: 1.5, the thickness is 150 nm, the annealing temperature is 100 鈩，

本文編號：1850156