本文選題：FPC + 特性阻抗線厚(T)��； 參考：《蘇州大學》2016年碩士論文

【摘要】：本研發實例課題,聚焦傳輸線的特性阻抗參數。優化提取三因素作為自變量,以便及時監測特性阻抗參數的質量穩定。柔性線路板(FPC)的特性阻抗控制是實現柔性線路板性能的重要一環。如何準確快捷地解決實際生產中的特性阻抗控制研究具有明確的工程意義。本工作側重FPC在生產過程中的技術工藝對于特性阻抗控制影響的研究,結合生產模式下由于不同材料、不同結構條件產生的數據,針對性地設計多組生產實驗,通過對特性阻抗(因變量)的模擬計算對比實際間接測量,經過驗證,得出如下結果:(1)FPC特性阻抗線厚(H)對FPC特性阻抗有直接影響;對應考量的自變量參數是:特性阻抗線厚(T)。(2)FPC特性阻抗線寬(W),對FPC特性阻抗有直接影響;對應考量的自變量參數分別是:特性阻抗線寬(W)。(3)覆蓋在FPC特性阻抗線上的掩膜層厚度(T)對FPC特性阻抗有直接影響;對應考量的自變量參數分別是:掩膜層厚度(T)。綜上試驗得到結論有(按照貢獻優先級的降冪排列):特性阻抗線厚(H),特性阻抗線寬(W),掩膜層厚度(T)是影響FPC特性阻抗的重要因素;針對結構要求和不同客戶要求,這些因素之間需要合理調配。
[Abstract]:This research and development example subject, focus transmission line characteristic impedance parameter.Three factors are extracted as independent variables to monitor the quality stability of characteristic impedance parameters in time.The characteristic impedance control of flexible circuit board (FPC) is an important part of realizing the performance of flexible circuit board.The research on how to solve the characteristic impedance control in actual production accurately and quickly has definite engineering significance.This work focuses on the study of the influence of FPC technology in the production process on the characteristic impedance control. Combining with the data produced by different materials and different structural conditions under the production mode, the multi-group production experiments are designed pertinently.By comparing the simulation calculation of characteristic impedance (dependent variable) with the actual indirect measurement, it is verified that the following results are obtained: 1) the characteristic impedance line thickness (H) has direct influence on the characteristic impedance of FPC.The parameters of independent variables are as follows: the line width of characteristic impedance of FPC is directly affected by the line thickness of characteristic impedance.The parameters of independent variables considered are as follows: the thickness of the mask (T) overlaid on the characteristic impedance line of FPC has a direct effect on the characteristic impedance of FPC, and the parameter of independent parameter is: the thickness of the mask layer is T ~ ((1)), and the parameter of the independent parameter is: the thickness of the mask layer is T ~ ((3)).It is concluded from the above experiment that (according to the descending power of the contribution priority, the characteristic impedance line thickness, the characteristic impedance line width, the mask thickness and the thickness of the mask layer) are the important factors affecting the characteristic impedance of FPC, and the structural requirements and different customer requirements are considered.These factors need to be properly deployed.
【學位授予單位】：蘇州大學
【學位級別】：碩士
【學位授予年份】：2016
【分類號】：TN41

【參考文獻】

相關期刊論文 前7條

1 楊雷;林開偉;張俊濤;;電源系統阻抗對電路板ESD測試的影響[J];物聯網技術;2014年11期

2 黃樨楠;;印刷電路板影響信號完整性的頻域分析[J];火控雷達技術;2010年01期

3 周蕓;柯敏毅;;高速PCB板設計研究[J];通信電源技術;2008年02期

4 何波;崔浩;何為;莫云綺;張宣東;徐景浩;關健;;COF(Chip on Film)30μm/30μm精細線路的研制[J];印制電路信息;2008年03期

5 李春彪;利用能量分析法解決電動機動力系統中的功率因數問題[J];電力電容器;2005年01期

6 秦庚 ,鄔寧彪 ,李小明;印制電路板特性阻抗的測試技術[J];印制電路信息;2004年11期

7 曹安照,田麗;介電常數、介質角正切對PCB特性阻抗的影響[J];自動化與儀器儀表;2003年06期

相關碩士學位論文 前1條

1 劉煒華;基于Genesis軟件的特性阻抗板的設計與實現[D];電子科技大學;2015年

，

本文編號：1763613