本文選題：氣體絕緣開關設備 + 開關操作��； 參考：《高電壓技術》2015年05期

【摘要】：智能變電站多將保護和控制以及監測等電子設備下放到匯控柜內,由于距離電磁騷擾源更近,使得這些電子設備的電磁兼容問題更加突出。為此,運用自制的電磁瞬態測量系統,對某500 kV氣體絕緣變電站調試期間隔離開關和斷路器操作在匯控柜電流互感器組件端口產生的騷擾電壓進行了測量。測量結果顯示,氣體絕緣開關設備匯控柜內智能組件端口共模騷擾電壓最大值為326.75 V,差模騷擾電壓最大值為189.84 V。并分析比較了隔離開關操作、斷路器合閘操作和斷路器分閘 合閘 閘操作時端口騷擾電壓的差異。斷路器操作時端口騷擾電壓有可觀的幅值水平,尤其是斷路器分閘 合閘 分閘操作時端口騷擾電壓在幅值、微脈沖持續時間和上升沿上較隔離開關操作時有更為嚴重的情況出現。最后,研究了IEC 61000-4-18阻尼振蕩波試驗標準與實測波形的對應情況。實測波形參數和標準波形參數略有差異,總體的對應情況較好。實測端口的電磁騷擾水平低于IEC 61000-4-18標準的試驗等級1。
[Abstract]:In intelligent substation, many electronic equipments, such as protection, control and monitoring, are transferred to the control cabinet, so the electromagnetic compatibility problem of these electronic devices is more prominent because of the closer distance from the electromagnetic disturbance source. For this reason, the disturbance voltage generated by the operation of the isolating switch and circuit breaker on the terminal of the current transformer module of the control cabinet is measured by using the self-made electromagnetic transient measurement system during the debugging of a 500 kV gas insulated substation. The measurement results show that the maximum common mode disturbance voltage and differential mode disturbance voltage are 326.75 V and 189.84 V respectively. The difference of the port disturbance voltage between the isolating switch operation, the breaker closing operation and the breaker opening and closing operation is analyzed and compared. The disturbance voltage of the port of the circuit breaker has a considerable amplitude level, especially the disturbance voltage of the port of the circuit breaker is in the amplitude of the opening and closing operation of the circuit breaker. The micropulse duration and rising edge are more serious than when the disconnect switch is in operation. Finally, the correspondence between the test standard of IEC 61000-4-18 damping oscillation wave and the measured waveform is studied. The measured waveform parameters are slightly different from the standard waveform parameters, and the overall correspondence is better. The electromagnetic disturbance level of measured ports is lower than that of IEC 61000-4-18 standard.
【作者單位】： 華北電力大學高電壓與電磁兼容北京市重點實驗室;國網江蘇省電力公司電力科學研究院;
【基金】：國家重點基礎研究發展計劃項目(973計劃)(2011CB209405) 江蘇省電力公司科技項目(編號略) 國家電網公司科技項目(SGRI-BB-71-13-003)~~
【分類號】：TM452;TM63

【參考文獻】

相關期刊論文 前10條

1 侯俊,王建國,饒章權,余軍,周文俊,胡瑜;500kV隔離開關操作時電流互感器二次側干擾信號的測試與分析[J];電測與儀表;2005年06期

2 崔翔;2002年國際大電網會議系列報道——電力系統電磁兼容研究進展[J];電力系統自動化;2003年04期

3 張禹芳;宋繼明;;500kV交流輸變電工程啟動調試中斷路器分合分試驗的探討[J];電網技術;2007年17期

4 史保壯,李智敏,張文元,邱毓昌;超高壓 GIS 中快速暫態過電壓造成危害的原因分析[J];電網技術;1998年01期

5 李小建;鐘堯;王任;霍宏;;超高壓系統隔離開關操作電磁騷擾的時頻特性[J];高電壓技術;2012年11期

6 詹花茂;趙承楠;段韶峰;李成榕;李志兵;歐陽卓;;氣體絕緣開關設備的隔離開關分合空載短母線時特快速暫態過電壓及特快速暫態電流測量[J];高電壓技術;2013年06期

7 陳珉;馬國明;李成榕;孫澤來;陳維江;丁衛東;;氣體絕緣開關設備介質窗口式特快速暫態過電壓測量用傳感器研制[J];高電壓技術;2014年03期

8 關永剛;郭s鉉，

本文編號：2114432