本文選題：配電網 + 變電站　； 參考：《西安科技大學》2014年碩士論文

【摘要】：配電網是電力輸送到用戶的最后環節，其可靠性直接影響到對用戶的供電質量，配電網的最大供電能力的評估與計算也成為了評價配電網的重要指標之一。最大供電能力(Total Supply Capability, TSC)是指一定供電區域內配電網滿足N-1安全準則條件下并考慮到實際運行約束下的最大負荷供應能力。 對配電網最大供電能力進行合理準確的評估與計算對提高配電網的可靠性有著重要的意義，不僅能夠反映配電網的供電水平，更重要的是能夠通過基于最大供電能力的一系列指標發現配電網的薄弱環節等，還能夠?yàn)樨?fù)荷的合理優化，提高設備的利用水平等提供指導。 目前的供電能力的研究主要集中在對計算模型的搭建和修正。計算方法主要有解析法和模型法兩類，典型的有：容載比法、最大最小負荷倍數法、網絡最大流法、基于直流潮流模型和交流潮流模型的計算方法以及模糊計算方法等。 本文首先對已有的最大供電能力的方法進行了比較和分析，，建立本文所需的計算模型，建立起設備的容量矩陣，負荷轉移關系矩陣等。 其次建立反映限制配電網供電能力的主要因素的分層供電能力指標體系。定義了饋線層最大供電能力、變壓器層最大供電能力、饋線與變壓器共同約束的最大供電能力、進線層最大供電能力和綜合最大供電能力等分層最大供電能力指標，定義了反映相鄰層設備供電能力的匹配程度的匹配度系列指標，定義了反映各設備的實際負荷與最大供電能力條件下應供出的負荷的差異的充盈度系列指標。 最后論述了基于上述指標對限制配電網最大供電能力的因素進行分析的方法。結合實例對所提出的指標和方法進行了詳細說明，結果表明了其可行性和有效性。
[Abstract]:Distribution network is the last link of power transmission to users, and its reliability directly affects the quality of power supply to users. The evaluation and calculation of the maximum power supply capacity of distribution network has become one of the important indexes of power distribution network evaluation. Total supply capability (TSC) refers to the maximum load supply capacity of the distribution network in a certain power supply area under the condition of N-1 security criterion and considering the actual operation constraints. It is important to evaluate and calculate the maximum power supply capacity of distribution network reasonably and accurately, which can not only reflect the power supply level of distribution network, but also improve the reliability of distribution network. More importantly, it can find the weak links of the distribution network through a series of indexes based on the maximum power supply capacity, and can also provide guidance for the rational optimization of the load and the improvement of the utilization level of the equipment. At present, the research of power supply capacity mainly focuses on the construction and modification of the calculation model. There are two kinds of calculation methods: analytical method and model method. Typical methods include capacity load ratio method, maximum and minimum load multiple method, network maximum flow method, calculation method based on DC power flow model and AC power flow model, and fuzzy calculation method. In this paper, the existing methods of maximum power supply capacity are compared and analyzed, and the calculation model, capacity matrix, load transfer relation matrix and so on are established. Secondly, the index system of hierarchical power supply capacity is established, which reflects the main factors that limit the power supply capacity of distribution network. The maximum power supply capacity of feeder layer, the maximum power supply capacity of transformer layer, the maximum power supply capacity of feeder and transformer, the maximum power supply capacity of feed layer and comprehensive maximum power supply ability are defined. The matching degree series index which reflects the matching degree of the power supply capacity of the adjacent layer equipment and the filling degree series index reflecting the difference between the actual load of each equipment and the load that should be supplied under the condition of the maximum power supply capacity are defined. Finally, the method of analyzing the factors limiting the maximum power supply capacity of distribution network based on the above indexes is discussed. The results show the feasibility and effectiveness of the proposed method.
【學位授予單位】：西安科技大學
【學位級別】：碩士
【學位授予年份】：2014
【分類號】：TM711

【參考文獻】

相關期刊論文 前10條

1 麻秀范,鐘暉,王偉,張粒子;城市配電網接線模式研究[J];東北電力學院學報;2005年02期

2 劉健;趙樹仁;張小慶;宋曉林;張志華;;配電網故障處理關鍵技術[J];電力系統自動化;2010年24期

3 劉健;司玉芳;;考慮負荷變化的配電網架安全評估及其應用[J];電力系統自動化;2011年23期

4 肖峻;谷文卓;郭曉丹;王成山;李方興;;配電系統供電能力模型[J];電力系統自動化;2011年24期

5 肖峻;郭曉丹;王成山;張躍;;基于供電能力的配電網聯絡有效性評價與化簡方法[J];電力系統自動化;2012年08期

6 肖峻;李振生;張躍;;基于最大供電能力的智能配電網規劃與運行新思路[J];電力系統自動化;2012年13期

7 周建英,宋奕冰,劉憲林,婁和恭,婁北;網絡最大流法在配電網線損計算中的應用[J];電力系統及其自動化學報;2000年05期

8 邱麗萍;范明天;;城市電網最大供電能力評價算法[J];電網技術;2006年09期

9 陳金玉 ,金文龍;城網規劃中關于變電容載比的取值問題[J];供用電;2004年05期

10 劉健;殷強;張志華;;配電網分層供電能力評估與分析[J];電力系統自動化;2014年05期

本文編號：2088438