發布時間：2018-06-16 04:18

  本文選題：電致發光片 + 驅動電路�。� 參考：《電子科技大學》2014年碩士論文

【摘要】：電致發光片是一種冷光源,具有驅動電壓高、電流小、功耗小等特點。近年來,能源危機成為廣泛關注的焦點,節能減排也成為新世紀的重要口號,世界各國都大力發展節能設備。作為新一代的照明顯示設備,電致發光片的應用受到越來越多的關注,電致發光片驅動電路的設計也成為電力電子領域內的重要課題。本課題來源于國家重大科技02專項,流片采用電子科大與上華公司合作開發的BCD工藝平臺,成功開發出一款用于驅動電致發光片的芯片。傳統的電致發光片驅動電路采用變壓器以及一些分立器件構成,因此導致它占用體積過大,重量比較重,成本較高,本文設計的電致發光片驅動電路采用集成電路的設計方法,將大部分外圍器件集成在芯片內部,因此應用電路的面積較小,成本也比較低。該驅動芯片的參數和指標包括:穩定輸出電壓100V以上;輸出頻率可調;工作電壓范圍3~5V;雙端輸出信號可直接驅動電致發光片。本文設計的電致發光片驅動電路,采用Boost升壓電路獲得100V以上的直流高電壓,采用H橋電路將直流電壓轉換為交流方波。整體電路共有六個模塊,即Boost升壓電路、基準電流源電路、振蕩器電路、使能電路、H橋邏輯控制電路、H橋模塊,對于這六個模塊,本文作者全部都通過仿真軟件進行設計驗證。目前各個子電路和整體電路均通過驗證,功能全部符和設計要求。本文的芯片在版圖設計中,將高壓模塊和低壓模塊分開隔離布局,高壓管的耐壓值在100V以上,本文通過一種LDMOS來實現,并在無錫華潤上華公司完成流片。作者及其團隊已經完成所有模塊的測試工作,又設計了芯片的應用系統電路,完成芯片應用系統的測試工作。通過結果可以看出,芯片功能正常,所有參數都符合設計指標。目前芯片已經通過中國測試研究院的第三方驗證,本論文中的所有數據均通過第三方認證。
[Abstract]:Electroluminescent chip is a cold light source with high driving voltage, low current and low power consumption. In recent years, energy crisis has become the focus of attention, energy saving and emission reduction has become an important slogan in the new century. As a new generation of lighting display devices, the application of electroluminescent devices has attracted more and more attention. The design of electroluminescent device driving circuit has become an important subject in the field of power electronics. This topic comes from the national important science and technology 02 special project, the stream piece uses the BCD craft platform which the electronic science and technology university and the Shanghai China company develops, successfully develops a chip which is used to drive the electroluminescent chip. The traditional electroluminescent chip drive circuit is composed of transformer and some discrete devices, so it takes up too much volume, heavy weight and high cost. The driving circuit of electroluminescent chip designed in this paper adopts the design method of integrated circuit. Most of the peripheral devices are integrated inside the chip, so the area of the application circuit is smaller and the cost is lower. The parameters and specifications of the drive chip include: stable output voltage above 100V, adjustable output frequency, operating voltage range of 3V / 5V, and double end output signal can directly drive the electroluminescent chip. In this paper, the drive circuit of electroluminescent chip is designed. The boost circuit is used to obtain the high DC voltage over 100V, and the H-bridge circuit is used to convert the DC voltage to AC square wave. The whole circuit has six modules, namely boost circuit, reference current source circuit, oscillator circuit, enable circuit and H-bridge logic control circuit. For these six modules, the author of this paper designs and verifies them by simulation software. At present, each sub-circuit and the whole circuit have passed the verification, the function all characters and the design request. In the layout design of the chip, the high voltage module and the low voltage module are separated and the voltage value of the high voltage tube is more than 100 V. in this paper, a kind of LDMOS is used to realize the chip, and the flow sheet is completed in Wuxi China Resources Shanghua Company. The author and his team have completed the testing of all modules, and designed the application system circuit of the chip to complete the testing work of the chip application system. The results show that the chip function is normal, all parameters are in line with the design index. At present, the chip has been verified by the third party of the China Institute of testing, and all the data in this paper are certified by the third party.
【學位授予單位】：電子科技大學
【學位級別】：碩士
【學位授予年份】：2014
【分類號】：TM923.01

【相似文獻】

相關期刊論文 前10條

1 賈林;;牡丹江第二發電廠輸煤系統程序控制介紹(二)——電致發光屏及其應用[J];黑龍江電力技術;1982年01期

2 張輝;巫松楨;謝恒X;;碳化硅電致發光對絕緣材料電性能的影響[J];絕緣材料通訊;1989年02期

3 王大華;王翔;;電致發光屏的研制[J];常州工業技術學院學報;1990年02期

4 熊艷;;一種藍光聚合物電致發光器件的穩定性能研究[J];長江大學學報(自然科學版)理工卷;2009年02期

5 喬智;;新型電致發光聚合物的合成[J];長春理工大學學報(自然科學版);2009年03期

6 林家齊;鐘志白;李彩霞;雷清泉;;聚對苯二甲酸乙二酯薄膜的電致發光研究[J];哈爾濱工業大學學報;2006年06期

7 楊凱;張冠軍;孫涵;嚴璋;;聚合物絕緣材料電致發光現象研究的進展[J];高電壓技術;2008年01期

8 李和;電致發光數字鐘在暗室中的應用[J];感光材料;1991年06期

9 吳正中,顧廣頤,邵繼紅;礦井電致發光安全頭燈[J];光學儀器;1998年05期

10 張華西;陳浩;李瑛;蔣青;謝明貴;啜玉濤;鄒德春;;新型烷基芴共聚物的合成及電致發光性質[J];高分子材料科學與工程;2006年02期

相關會議論文 前10條

1 鄭巖;吳虹;;電致發光線性器件[A];上海市照明學會成立30周年慶典暨四直轄市照明科技論壇、長三角照明科技論壇、上海市照明學會2008年年會論文集[C];2008年

2 胡煜峰;張彥廣;李洪超;王利祥;馬東閣;;雙極性聚合物的電致發光[A];2002年中國光學學會年會論文集[C];2002年

3 章婷;徐征;陳曉紅;蘇艷梅;劉育新;沈鴻;;電壓調制變色的摻雜有機電致發光器件[A];第九屆全國發光學術會議摘要集[C];2001年

4 鄭巖;;一種新型節能環保的城市照明發光顯示器件——電致發光線性器件[A];中國長三角照明科技論壇論文集[C];2004年

5 姜鴻基;馮嘉春;韋瑋;黃維;;2,7-2(9,9-2十二烷基-2-(2,4-2氟苯)-芴)芴酮的合成[A];2005年全國高分子學術論文報告會論文摘要集[C];2005年

6 丁w，

本文編號：2025269