本文選題：三相組合式　切入點：串聯間隙　出處：《電瓷避雷器》2014年06期

【摘要】：簡述了行業標準JB/T 10609-2006《交流三相組合式有串聯間隙金屬氧化物避雷器》應修訂的各種原因。從避雷器的持續運行電壓、避雷器的額定電壓、避雷器的工頻放電電壓、避雷器的保護水平、避雷器動作負載試驗、避雷器工頻電壓耐受時間特性試驗、避雷器局部放電試驗等幾方面,論述了修訂后的標準和JB/T 10609-2006標準的主要技術差異,并分析了典型避雷器的持續運行電壓參數及20 k V系統電站用典型避雷器的電氣性能參數選取時的考慮因數,同時,在修訂的標準中提出了該參數的建議值。為便于修訂和執行標準,結合相關資料,介紹了避雷器相-相間的工頻放電電壓試驗方法和沖擊放電電壓試驗方法。
[Abstract]:The reasons why the industry standard JB/T 10609-2006 "alternating current three-phase combined metal oxide arrester with series gap" should be revised are briefly described.From the continuous operation voltage of the arrester, the rated voltage of the arrester, the power frequency discharge voltage of the arrester, the protection level of the arrester, the load test of the arrester action, the test of the voltage tolerance time characteristic of the arrester's power frequency,The main technical differences between the revised standard and JB/T 10609-2006 standard are discussed.The continuous operation voltage parameter of typical arrester and the factor of considering the selection of electrical performance parameters of typical arrester for power station in 20kV system are analyzed. At the same time, the suggested value of this parameter is put forward in the revised standard.In order to revise and implement the standard, the test methods of power frequency discharge voltage and impulse discharge voltage between phases of arrester are introduced.
【作者單位】： 西安高壓電器研究院有限責任公司;浙江永固電纜附件有限公司;
【分類號】：TM862

【參考文獻】

相關期刊論文 前3條

1 張益民;程文怡;;額定電壓52kV及以下有串聯間隙避雷器若干問題的探討[J];電瓷避雷器;2011年05期

2 張益民;王紹君;楊華;;城市軌道交通用直流無間隙金屬氧化物避雷器若干問題淺析[J];電瓷避雷器;2013年05期

3 趙U_e，

本文編號：1702758