本文關鍵詞： 超級電容器 多孔鎳 陽極氧化鋁 循環伏安　出處：《華南理工大學》2014年碩士論文　論文類型：學位論文

【摘要】：人類社會正面臨能源緊缺和環境污染的挑戰，新型能源材料和儲能材料成為了世界各國科學重要發展方向。作為一種新型儲能材料，電化學超級電容器材料由于具有高充放電速率和長循環壽命等優點，而引起各國政府和科學家廣泛關注。其中，，NiO/Ni(OH)2由于具有超高的比電容（理論電容值是3750F/g），對環境無污染以及價格低廉等優勢，而成為最有潛力的超級電容器電極材料之一。本論文突破電極材料傳統制備方法的束縛，將模板法和循環伏安生長法相結合制備三維連通氫氧化鎳/鎳復合電極，并通過調節復合電極微結構及成分，探索制備高性能電化學超級電容電極材料的有效途徑。 本論文首先通過陽極氧化腐蝕鋁制備了大比表面積多孔鋁，并通過電鑄復型多孔鋁獲得了三維結構多孔鎳材料，最后獲得了高性能三維氫氧化鎳/鎳復合電極材料。實驗結果表明：采用電化學氧化還原循環法在-1.5V~-0.2V之間對多孔鎳進行粗糙化處理，可以獲得大比表面積的多孔鎳；對粗糙多孔鎳在0V~0.5V之間采用電化學原位生長法制備Ni(OH)2，經過XRD測試表明活性物質的主要成分是α-Ni(OH)2；電化學性能測試表明，多孔Ni(OH)2/Ni復合電極具有很高的體積比電容(1559F/cm3)和很大的面積比電容(7.01F/cm2)(掃描速率為1mV/s)，該復合電極同時具有優異的循環穩定性，在掃描速率為10mV/s循環測試500次后，其容量的保持率達到93%。 本論文通過周期性陽極氧化和化學腐蝕相結合制備了三維互聯層狀結構的陽極氧化鋁光子晶體模板，并采用電鑄工藝進行復型得到了層狀納米結構多孔鎳集流體，然后采用循環伏安法原位生長獲得多孔α-Ni(OH)2/Ni復合電極。對50層三維多孔Ni(OH)2/Ni復合電極進行恒流充放電測試(5mA/cm2)，獲得了超高的體積比電容(1387F/cm3)和很大的面積比電容(2.51F/cm2)，同時也表現出了優秀的循環穩定性，在掃描速率為10mV/s循環壽命測試1000次之后，容量幾乎沒有任何的衰減。層狀復合電極具有優異電化學性能的主要原因是優化的多孔納米微結構提高了電極材料的比表面積，而超薄的活性物質層提高了電極材料的有效利用率。
[Abstract]:Human society is facing the challenge of energy shortage and environmental pollution. New energy materials and energy storage materials have become an important development direction of science all over the world. Electrochemical supercapacitor materials have the advantages of high charge / discharge rate and long cycle life. Among them, nio / nio / nio / nio / nio / nio / nio / nio / nio / nio / Nio / Nio / Nio / Nio / Nio / NiOHH2 has the advantages of high specific capacitance (the theoretical capacitance is 3750F / g), no pollution to the environment and low price. In this paper, the template method and cyclic voltammetry (CV) method are combined to prepare three dimensional connected nickel hydroxide / nickel composite electrode, which is one of the most promising electrode materials for supercapacitor. By adjusting the microstructure and composition of the composite electrode, an effective way to prepare high performance electrochemical supercapacitor electrode material was explored. In this paper, porous aluminum with large specific surface area was prepared by anodic oxidation of aluminum, and three dimensional porous nickel material was obtained by electroforming porous aluminum. Finally, high performance three dimensional nickel hydroxide / nickel composite electrode materials were obtained. The experimental results show that porous nickel with large specific surface area can be obtained by roughening porous nickel between -1.5 V and -0.2 V by electrochemical redox cycle method. The coarse porous nickel was prepared by electrochemical in-situ growth method between 0 V and 0.5 V. The XRD test showed that the main component of the active substance was 偽 -NiOH2, and the electrochemical performance test showed that the main composition of the active material was 偽 -NiOH2. The porous Ni(OH)2/Ni composite electrode has a high volume specific capacitance of 1559F / cm ~ (3) and a large area specific capacitance of 7.01F / cm ~ (-2) (scan rate is 1 MV / s). The composite electrode also has excellent cycling stability. After 500 cycles of scanning rate of 10 MV / s, the capacity retention rate of the composite electrode is 93%. In this paper, the anodic aluminum oxide photonic crystal template with three dimensional interconnected layered structure was prepared by the combination of periodic anodic oxidation and chemical corrosion, and the porous nickel collector with layered nanostructure was obtained by electroforming process. Then the porous 偽 -NiOHH / 2 / Ni composite electrode was obtained by in situ growth by cyclic voltammetry. The constant current charge-discharge test of 50 layers of three-dimensional porous Ni(OH)2/Ni composite electrode was carried out, and the ultra-high volume specific capacitance of 1387F / cm _ 3 and a large area specific capacitance of 2.51F / cm _ 2 were obtained. Showing excellent cyclic stability, After 1000 cycles at a scanning rate of 10 MV / s, the capacity of the layered composite electrode has almost no attenuation. The main reason for the excellent electrochemical performance of the layered composite electrode is that the optimized porous nanostructure increases the specific surface area of the electrode material. The effective utilization ratio of electrode material was improved by the thin active material layer.
【學位授予單位】：華南理工大學
【學位級別】：碩士
【學位授予年份】：2014
【分類號】：TM53

【參考文獻】

相關期刊論文 前6條

1 周勤儉,袁慶文,覃事彪,王利君,曾子高,董正強;正極材料α-Ni(OH)_2的研究進展[J];電池;2003年02期

2 魯蓉;張建成;;超級電容器儲能系統在分布式發電系統中的應用[J];電力科學與工程;2006年03期

3 陳鈞武;電鑄發展現狀[J];電鍍與精飾;1996年02期

4 翟海軍,王先友,楊紅平;摻雜α-Ni(OH)_2的電化學性能研究[J];電源技術;2002年04期

5 梁逵,陳艾,李悅;超大容量離子電容器碳納米管與氧化鎳復合電極材料的研究[J];硅酸鹽學報;2002年04期

6 田周玲,矯慶澤;水熱法制備氫氧化鎳納米線[J];無機化學學報;2004年12期

本文編號：1533152